List the uses of usart, Electrical Engineering

Assignment Help:

List the uses of USART.

USART-Universal Synchronous Asynchronous Receiver-Transmitters.

It is used to transmit and receive the data in serial communication mode.

It is used to change parallel data into serial data or vice-versa

It is used to line MODEM and establish serial communication MODEM over telephone lines.

 


Related Discussions:- List the uses of usart

Find the current in resistance, Q. Obtain the Thévenin and Norton equivalen...

Q. Obtain the Thévenin and Norton equivalent circuits for the portion of the circuit to the left of terminals a-b in Figure, and find the current in the 200- resistance.

For sign flag , For Sign Flag  CP ( Call on plus ) CM (Call on minus ...

For Sign Flag  CP ( Call on plus ) CM (Call on minus ) Instruction CP call  the subroutine  from the  specified  memory  location if  sign flag is not set or reset( S=0)

Half-wave rectifier, Half-wave rectifier: A half-wave rectifier will j...

Half-wave rectifier: A half-wave rectifier will just only give one peak per cycle and for this reason and other reasons is only employed in extremely small power supplies. A f

What is a co-processor, What is a co-processor? 8087 NDP (numerical da...

What is a co-processor? 8087 NDP (numerical data processor) is also termed as math co-processor that is used in parallel with the major processor for number crunching applicat

What is cascade, An arrangement of Windows so every window is neatly stacke...

An arrangement of Windows so every window is neatly stacked with only the title bar of every window is showing.

Electrical Engineering Design Report, hi there i just need help for Electri...

hi there i just need help for Electrical Engineering Design Report about any topic (prefer charger and inverter) which should be include Summary,Table of contents,Introduction,Body

Frequency response of a r-c coupled amplifier, Q. Write a short note on the...

Q. Write a short note on the frequency response of a R-C coupled amplifier. At low frequencies ( , the reactance of coupling capacitor Cc is quite high and hence very small pa

Explain the working principle of an opto coupler, Q. Explain the working pr...

Q. Explain the working principle of an opto coupler? When it is necessary to block the voltage between one electronic circuit and another, and transfer the signal at the same t

Write explanatory notes on paging, Write explanatory notes on Paging. T...

Write explanatory notes on Paging. The memory paging mechanism located inside the 80386 and above permits any physical memory location to be allocated to any linear address. Th

Design a battery charger, The problem with a battery charger (say, for port...

The problem with a battery charger (say, for portable devices) is that it continues to draw power even after the battery is fully charged thereby wasting electricity. In addition,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd