List few applications of microprocessor-based system, Electrical Engineering

Assignment Help:

List few applications of microprocessor-based system.

It is used:

i. For measurements, display and control of current, voltage, temperature, pressure, etc.

ii. For traffic control and industrial tool control.

iii. For speed control of machines.

 


Related Discussions:- List few applications of microprocessor-based system

Ac waveform, which ckt. Or components using for irregular ac sine wave ...

which ckt. Or components using for irregular ac sine wave change into pure sine wave.......

Electronics, why inductive load is use in electronics circuit?

why inductive load is use in electronics circuit?

Saturation or active mode, Saturation or active mode While V GS  ...

Saturation or active mode While V GS   > V th  and  V DS   > (V GS   - V th ) The switch is turned on, and a channel has been made that allows current to flow

Switching characteristics, Switching Characteristics Switching  charact...

Switching Characteristics Switching  characteristics  of BJT  are shown  in figure. Due  to the presence of internal  capacitances BJT  cannot be  turned  instantly. Initially

Transformers, A 440v 4-pole dc generator takes an armature current of 50A w...

A 440v 4-pole dc generator takes an armature current of 50A when rotating at 626 rpm. the armature circuit resistance is 0.25 ohms. determine the generated emf?

Show the force exerted on each is about one million tons, Q. Consider two 1...

Q. Consider two 1-C charges separated by 1min free space. Show that the force exerted on each is about one million tons.

What do you mean by pinch off voltage, Q. What do you mean by Pinch off vol...

Q. What do you mean by Pinch off voltage? As the voltage Vds is increased from 0 to a few volts, the drain current will increase as  determined by Ohm's law and the plot of Id

Cipper, when i/p voltg is grater than battery diode is clse or open

when i/p voltg is grater than battery diode is clse or open

Find the current, 1. A 1 μm long and 100 μm 2 cross-sectional area silicon...

1. A 1 μm long and 100 μm 2 cross-sectional area silicon bar is doped with 10 16 /cm 3 phosphorous. Use the graph below to: a. Find the current at 300°K with 10 V applie

Designing of a 2 way cross-over circuit for loudspeaker, Loudspeakers using...

Loudspeakers using single driver are unable to cover the entire frequency band from low frequency to high frequency. Sometimes multiband frequency is required for the bass enhancem

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd