Limit of proportionality, Mechanical Engineering

Assignment Help:

Limit of proportionality:

Limit of proportionality is the stress at which the stress - strain diagram ceases to be a straight line that is, stress at which the extension ceases to be directly proportional to corresponding stresses.

 

 


Related Discussions:- Limit of proportionality

SOM, 01-- what is the scope of som? 02-- how can we learn and understand sh...

01-- what is the scope of som? 02-- how can we learn and understand shear force and bending moment diagram?

Flow rate, how to calculate flow rate of liquid nitrogen? melting point(-21...

how to calculate flow rate of liquid nitrogen? melting point(-210deg) boiling point(-195.8deg) critical temp(-149.9deg) relative density(0.8) specific gravity(808.5kg/m^3) rel

Compare otto cycle with diesel cycle, Compare otto cycle with Diesel cycle:...

Compare otto cycle with Diesel cycle: Sol.: These two cycles can be compared on the basis of either the same compression ratio or the same maximum pressure and temperature.

Functions of geometric modeling, Q. Functions of geometric modeling? De...

Q. Functions of geometric modeling? Design Analysis • Evaluation of area, volume, mass and inertia properties. • Interference checking in assemblies. • Analysis of

Chemistry, what desaster made chemistry

what desaster made chemistry

Necessity of lubrication , Necessity of Lubrication To lubricate t...

Necessity of Lubrication To lubricate the various parts of engine. The supplementary function of lubrication is to cool and clean the engine parts. To prevent en

Show seismic loads for ground supported equipment, Q. Show Seismic Loads Fo...

Q. Show Seismic Loads For Ground Supported Equipment? V = C s W is the governing equation for horizontal seismic base shear of ground supported equipment. C s  = 1.2A v S/(RT

Compute the outside diameter of the shaft, Compute the outside diameter of ...

Compute the outside diameter of the shaft: A hollow shaft of diameter ratio is 0.4 is needed to transit 600 kW at 120 rpm. The maximum torque being 20% greater than the mean t

Laser sources-lasers with solid state lasing mediums, Lasers with Solid Sta...

Lasers with Solid State Lasing Mediums For an active medium, the solid state laser uses lasing ions which are suspended in a rod shaped solid matrix. These "dopants" in the rod

Changes in mechanical properties along with tempering, Changes in Mechanica...

Changes in Mechanical Properties along with Tempering: Tempering enhances the toughness and ductility of quenched steel though decreases hardness. Following figure demonstrate

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd