Just-in-time, Mechanical Engineering

Assignment Help:

Just-In-Time:

This unit begin with the discussion of Just-In-Time strategy. Several terms used in the process are also explained. JIT is an encompassing philosophy considering product design, equipment, selection, quality assurance, material management, job design, and productivity improvements. After describing JIT, Kanban is discussed with the rules and philosophy. Implementation of JIT in Industries is also explained. At last the unit ends giving detailed information regarding the advantages and disadvantages of using JIT and Kanban.


Related Discussions:- Just-in-time

Engineering design, 1) State five factors that must be considered when choo...

1) State five factors that must be considered when choosing a material. Discuss the importance to the engineer of each of these factors. 2) An engineer is planning to design a s

Mechanical design of the blowdown systems, Q. Mechanical design of the blow...

Q. Mechanical design of the blowdown systems? Mechanical design of the blowdown systems shall be sized for a continuous blowdown of a minimum of 1.0% of MCR. Fabricator may re

Communication protocols applicable in holonic manufacturing , Communication...

Communication Protocols Applicable in Holonic Manufacturing System Communication amongst agents plays an essential role in the Holonic manufacturing system. Exchange of informa

Firing rate demand for steam generator, Q. Firing Rate Demand for Steam Gen...

Q. Firing Rate Demand for Steam Generator? The firing rate for each Steam Generator is proportional to the feedwater flowing into that Steam Generator. Thus, the sum of the pa

Wire feed system, Wire Feed System The submerged arc welding machine of t...

Wire Feed System The submerged arc welding machine of the wire feed control may be of the following types: 1. Voltage sensitive system 2. Constant wire feed The voltage sensiti

What is hybrid sweep, Hybrid Sweep It combines linear and/or non-linear...

Hybrid Sweep It combines linear and/or non-linear sweep via set operations. In this case, two point sets are swept in two different directions and the two resulting swept volum

Hydro turbine, in hydro turbine vaccum is present in casing or not? & if no...

in hydro turbine vaccum is present in casing or not? & if not then how suction is take place?

Mechanical properties of materials, A tensile test on a specimen having an ...

A tensile test on a specimen having an initial diameter of 13.11 mm and an initial gauge length of 200.0 mm, gave the following data:

What is the pressure difference between the stations , (Bernoulli equation ...

(Bernoulli equation along a streamline) Water flows from station (1) to (2) around an expanding corner pipe, 3m high. The speed along the center streamline is 10 m/s at (1) and 5

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd