Jib crane mechanism, Mechanical Engineering

Assignment Help:

Jib crane Mechanism:

Sol.: Jib crane is taken in use to raise heavy loads. A load W is lifted up by pulling the chain through pulley D as shown in the adjacent figure. Member CD is known as tie and member AD is called as Tie is in tension and jib is in compression. AC is the vertical post. Forces in tie and jib can be calculated. Chain BD and Tie CD are not often horizontal. Determination of forces for AC given configuration and load is explained through numerical examples.

1082_Explain Jib crane Mechanism.png

 


Related Discussions:- Jib crane mechanism

Mockup of tube to tubesheet, what are the tests to carried out after mockup...

what are the tests to carried out after mockup preparation

Varignon theorem - mechanics, Varignon theorem: State Varignon's theo...

Varignon theorem: State Varignon's theorem. How it helps in determining of the moments? In which type of condition is it used? Sol.: Varignon's theorem also called Law

Maximum slope and maximum deflection, Maximum slope and maximum deflection:...

Maximum slope and maximum deflection: A simply supported beam of span l is subjected to two concentrated loads at one-third span through two supports. Discover the maximum slo

Tank insulation process, Q. Tank Insulation process? With Owner's appro...

Q. Tank Insulation process? With Owner's approval, spray urethane foam may be used. Manufacturer's recommendations for service temperature limit shall be followed for specific

Estimate the weight of the casting, Estimate the Weight of the Casting ...

Estimate the Weight of the Casting A Yoke casting shown in Figure is to be produced by sand casting process. Estimate the weight of the casting if the density of the material

Can you explain about fuel oil and dextrin, Q. Can you explain about Fuel O...

Q. Can you explain about Fuel Oil and Dextrin? Fuel Oil : It improves the mould ability of sand. Iron Oxide: It develops hot strength. Dextrin: It increases air sett

Copper-beryllium alloys, Copper-Beryllium Alloys Copper-beryllium allo...

Copper-Beryllium Alloys Copper-beryllium alloys comprise between 0.6 to 2% Be and 0.2 to 2.5% Cobalt. Such alloys can be precipitation hardened and cold worked to improve a te

OPITZ alternative, I am looking for an alternative coding system to the OP...

I am looking for an alternative coding system to the OPITZ coding system for my essay thanks

What is the basic working of cooling tower, Q. What is the basic working of...

Q. What is the basic working of Cooling Tower? Cooling towers are generally located downwind from process units to adequately disperse vapors (from exchanger leaks) and minimiz

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd