Illustrate the simplex transmission, Electrical Engineering

Assignment Help:

Q. Illustrate the Simplex Transmission?

Simplex Transmission

Data in a simplex channel is always one way. Simplex channels aren't often used as it is not possible to send back error or control signals to the transmit end. An illustration of a simplex channel in a computer system is the interface between keyboard and computer, in that key codes need only be sent one way from the keyboard to computer system.


Related Discussions:- Illustrate the simplex transmission

Describe the two core-excited states, Using the optimized 6-311G(d,p) geome...

Using the optimized 6-311G(d,p) geometry determined in question 1, perform the following equivalent core calculations for any two inequivalent carbons of butadiene: (a) Equivale

Write shorte note on carbon, Write shorte note on Carbon. Carbon: The...

Write shorte note on Carbon. Carbon: The rate of commutator wear in electrical machines is greatly decreased by using brushes made of carbon. Carbon (C) is also used in autom

Find the rotor copper loss, A three-phase, 50-hp, 440-V, 60-Hz, four-pole, ...

A three-phase, 50-hp, 440-V, 60-Hz, four-pole, wound-rotor inductionmotor operates at a slip of 0.03 at full load,with its slip rings short-circuited. The motor is capable of devel

Explain hand shakingfor the allocation of addresses, Explain Hand shakingfo...

Explain Hand shakingfor the allocation of addresses to memories and input output devices. Hand shaking: During an ASYNCHRONOUS data transfer is not based upon predetermined tim

Embedded system, comment instruction for LIST p=18f4550

comment instruction for LIST p=18f4550

Calculate the maximum analog output voltage, Q. For the 4-bit D/A converter...

Q. For the 4-bit D/A converter of Figure, calculate: (a) The maximum analog output voltage. (b) The minimum analog output voltage. (c) The smallest detectable analog outpu

Explain the test instruction, Explain the TEST instruction. TEST: The T...

Explain the TEST instruction. TEST: The TEST instruction executes the AND operation. The difference is as the AND instruction changes the destination operand, whereas the TEST

How can a jfet be used as a voltage controlled resistor, Q. How can a JFET ...

Q. How can a JFET be used as a voltage controlled resistor. Explain from drain characteristics? The region to the left of the pinch off locus is referred to as the ohmic region

Digital storage oscilloscope, #question.draw the block diagram pf digital s...

#question.draw the block diagram pf digital storage oscilloscope and briefly discuss about each block

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd