If engine does not start in wet or damp weather, Mechanical Engineering

Assignment Help:

If Engine Does Not Start in Wet or Damp Weather

Causes of Problem

Remedy

 

  • Insulators are not clean and dry
  • Fuel tank cap got cracked
  • Dust and/or moisture on secondary Coil terminal
  • Wet secondary circuit wires

 

 

  • Clean and dry insulator
  • Replace the cracked fuel tank cap
  • Clean and dry the coil
  • Dry the wires

 

 


Related Discussions:- If engine does not start in wet or damp weather

Thermal Stresses in Tapered Section, A rigidly fixed circular bar 1.75mm lo...

A rigidly fixed circular bar 1.75mm long uniformly tapers from 125mm dia. at 1 end to 100mm dia. at other end. If the max. stress in the bar is not to exceed 108MPa. Find the tempe

Determine the deflection of the spring, Determine the deflection of the spr...

Determine the deflection of the spring: A close coiled helical spring deflects 25 mm under a certain axial load. Determine the deflection of the second spring under the simila

Alloy materials control, Q. Alloy materials control? All low alloy and ...

Q. Alloy materials control? All low alloy and high alloy equipment components including fittings, flanges and sections of pipe and all welds shall be individually tested by Ven

Effect of individual alloying elements, Effect of Individual Alloying Eleme...

Effect of Individual Alloying Elements: Sulfur Sulfur is not a needed element in steel since in interferes along with hot rolling and forging resulting in hot-shortness

Non-ferrous materials, NON-FERROUS MATERIALS: Latest technology has be...

NON-FERROUS MATERIALS: Latest technology has been highly dependent on non-ferrous and alloys for in specific cases they represent the compensation of high strength and low wei

Determine the number of leaves and initial curvature, Determine the number ...

Determine the number of leaves and initial curvature: A leaf spring with a span of 1.40 m consist width and thickness of leaves to be 100 mm and 12 mm respectively. The maximu

Rubber hoses services tips, Rubber Hoses: Fuel or vacuum hoses should be i...

Rubber Hoses: Fuel or vacuum hoses should be installed so that end is bottomed into its fitting which would ensure adequate area for the hose clip to grip the hose beneath the fla

Vibration, what is vibration in terms of mechanical term

what is vibration in terms of mechanical term

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd