Identify three udp characteristics, Computer Networking

Assignment Help:

UPD is a layer 4 Transport protocol. It is connection-less due to it does establish a connection thus the 3 step handshake is not needed, it does NOT execute any flow control or acknowledgments. Any application that uses UDP must incorporate any required reliability.

Related Discussions:- Identify three udp characteristics

Determine sonet devices, Sonet Devices STS Mux or DMux either multiplex...

Sonet Devices STS Mux or DMux either multiplexes signals from multiple sources into an STS or demultiplexes an STS into different destination signals. Regenerator is a repea

What are the advantages of the intranet, What are the Advantages of the int...

What are the Advantages of the intranet The most easily noticeable difference between an Internet server and an Intranet server such as Lotus Notes is their design philosophy.

What are the main differences between ripv1 and ripv2, 1. What does RIP st...

1. What does RIP stand for? 2. What metric does RIP use for Path Selection? 3. If the metric used by RIP exceeds this value for a route it is considered unreachable, effec

Categories of encryption - decryption, Q. Categories of Encryption - Decryp...

Q. Categories of Encryption - Decryption ? Categories of Encryption/Decryption - Symmetric-key - encryption key (Ke) and the decryption key (Kd) are the same and secret

Ack received - trasnport layer, ACK Received If an ACK is received by ...

ACK Received If an ACK is received by the sender. The SR sender marks that packet as having been received by the receiver.

Explain short term and medium-term scheduling, What are short, long and med...

What are short, long and medium-term scheduling? Long term scheduler verifies which programs are admitted to the system for processing. It controls the degree of multiprogrammi

Create and simulate a network - netml system, Create and simulate a network...

Create and simulate a network similar to the one shown here, using the NetML system. The network is a little more complex, as depicted at the right. There is an extra node

Illustrate the bus backbone network, Q. Illustrate the Bus Backbone network...

Q. Illustrate the Bus Backbone network? - Topology is a bus - Utilized in networks such as 10Base5 or 10Base2 - Normally utilized to connect different buildings or to con

Quality of service, Networks are more frequently being prepared to allow sp...

Networks are more frequently being prepared to allow specification of the quality of service needed by users. For example: - a typical voice telephone call may give a QoS para

Which type of switching is considered to be ''wire speed'', Cut-Through is ...

Cut-Through is the best mode of switching. Store and Forward reads in the whole frame, confirms the frame is valid, and then forwards the frame onto the wire. Cut-Through only chec

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages