Ht metering, Electrical Engineering

Assignment Help:

HT Metering

The following type of meters is generally used for HT consumers:

  1. Trivector Meter,
  2. Bivector Meter, and
  3. Summation Meters.
  4. Trivector Meter

A well planned tariff covering an electricity service takes within account both the energy consumed, maximum demand and recording of power factor. Tariff of this kind comprises:

- Charge on energy consumed in kWh;

- Charge on maximum demand in kVA; and

- Charge on account of power factor, if it is below the exact limit (these charges are not required where energy charge is on kVAh basis).


Related Discussions:- Ht metering

What is frequency translation and product modulation, Q. What is Frequency ...

Q. What is Frequency Translation and Product Modulation? The basic operation needed to build modulators is the multiplication of two signals. Whenever sinusoids are multiplied,

Describing the steady state effect , Select the response describing the ste...

Select the response describing the steady state effect of increasing the air gap for otherwise identical devices, one operating with constant DC voltage excitation and one with con

Metal oxide field effect transistor, Metal Oxide Field Effect Transistor ...

Metal Oxide Field Effect Transistor The metal-oxide-semiconductor field-effect transistor (MOSFET/MOS-FET/MOS FET) is a device employed for amplifying or for switching electr

Derive the solution of the characteristic equation, For a vehicle suspensio...

For a vehicle suspension, a basic two-degree-of-freedom "quarter-car" model would be slightly more complicated than the spring-mass-damper system I chose to study in Figure 1. The

Explain the block diagrtam of d.c. voltmeter , Q.   Explain the block diagr...

Q.   Explain the block diagrtam of D.C. voltmeter with direct coupled amplifier. Sol. D.C, voltmeter with direct coupled Amplifier         The D.C. electronic voltmeters

Communication network, Assuming that the receiver sends a XOFF signal when ...

Assuming that the receiver sends a XOFF signal when the receive buffer is P% full in order to avoid any data or packet loss.

Electronic Devices, To demonstrate a practical method of testing semiconduc...

To demonstrate a practical method of testing semiconductor diodes.

Program counter , Program Counter (PC) It is a   16 bit  register.  It ...

Program Counter (PC) It is a   16 bit  register.  It is a memory  pointer. It stores  the memory address  of the next  byte of the program to be executed. Memory  address is of

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd