How many types of foundations are there, Mechanical Engineering

Assignment Help:

How many types of Foundations are there

Foundations are broadly classified into two types, viz., shallow and deep foundations with respect to  the width (B) and depth (D) below ground level

 


Related Discussions:- How many types of foundations are there

Stages in making a spot welding, Q.Show the procedure of spot welding ? ...

Q.Show the procedure of spot welding ? The steps involved in making a spot weld are listed below and shown but before spot welding one must make sure that (i) The job is clea

Dual combustion cycle, In an I.C. engine operating on the Dual combustion c...

In an I.C. engine operating on the Dual combustion cycle, the temperature of the working fluid (air) at the beginning of compression is 27ºC. The ratio of the maximum and minimum p

Thermodynamics, Problem specification 5 kg of air is contained in a piston-...

Problem specification 5 kg of air is contained in a piston-cylinder device, initially at a pressure of 2MPa and a specific volume of 0.08m3/kg. The air then expands, as an ideal ga

Drainage of the railway track - construction of railway line, Drainage of t...

Drainage of the Railway Track: It is necessary to keep the embankment free from water. This is done by providing side ditches, all along the edge of the embankment, and leadi

Stresses., temparature stresses in composite bars

temparature stresses in composite bars

Power sources-transformer type power sources, Transformer Type Power Source...

Transformer Type Power Sources These are the simplest and cheapest type available for arc welding. These are the mainly used for SMAW, AC SAW and gouging applications. These are

Laser surface treatment-transformation hardening, Transformation Hardening ...

Transformation Hardening The main features of the laser as a heat source for transformation hardening are: (A) Clean energy source. (B) Energy is localised: no heat spillage.

Evaluate mechanical work - thermodynamics, Evaluate mechanical work in diff...

Evaluate mechanical work in different steady flow process: Work done by steady flow process   and work done in non flow process,   1. Constant Volume Process; W 1-2 = V

Spring, direct shear and torsional shear of the coil

direct shear and torsional shear of the coil

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd