How are the cutting fluids classified, Mechanical Engineering

Assignment Help:

(a) How are the cutting fluids classified ? Explain every class with a couple of lines.

(b) A carbide cutting tool has tool life exponent n = 0.27. It gives a tool life of 60 min while machining a mild steel workpiece at a cutting speed of 120 m/min. calculate the tool life if its is to be cut at 20% higher cutting speed ?

(c) Write a couple of lines on :

(i) Tool life

(ii) Machineability

(iii) Machinability Index

(iv) Coated tools


Related Discussions:- How are the cutting fluids classified

Single-engine general aviation aircraft, The wing of a light, single-engine...

The wing of a light, single-engine general aviation aircraft has an area of 15.8 m 2 and a span of 9.6 m. The airfoil of the wing is NACA 65-415, which has a lift slope of 0.1033

Steps involved for method of section, Step s Involved for Method of Sectio...

Step s Involved for Method of Section: The different steps involved are stated below: (1) First find out support reaction by using equilibrium conditions. (2) The truss

LPP, (Hint Minimization problem -min X1 + X2, s.t. 2X1 + X2 = 12, X1 + 6X2 ...

(Hint Minimization problem -min X1 + X2, s.t. 2X1 + X2 = 12, X1 + 6X2 = 24, 5X1 + 8X2 = 24; X1, X2 = 0).

Calculate the machining time and the material removal rate, Calculate the M...

Calculate the Machining Time and the Material Removal Rate A through hole of 40 mm diameter and 50 mm depth is to be drilled in a mild steel component. The cutting speed can b

Calculate the mechanical output power, A 415 V, 5 kW, 50 Hz, 4-pole, 3-phas...

A 415 V, 5 kW, 50 Hz, 4-pole, 3-phase wound-rotor induction motor has the following characteristics:  Stator winding resistance R 1 = 2.1 Ω, Referred rotor windi

Explain the function phase of radial drilling machine, Function Phase: ...

Function Phase: Steps: 1. To identify the functions. To identify the functions regarding to the problem in radial drilling machine. Our project focus on the create an a

Need it fast, PROBLEM 1 (30 points) Consider a Boeing 747-400 at weight clo...

PROBLEM 1 (30 points) Consider a Boeing 747-400 at weight close to the maximum takeo? weight (MTOW) cruising at Mach 0.82 at an altitude of 32000 ft. (a) How much thrust is needed

Subsea Valves, Read two documents that will provide and answer the followin...

Read two documents that will provide and answer the following questions: 1) You will note from reading the above referenced specifications that fewer valve types are recommended fo

Simple Mechanisms, I have an assignment on kinematic chains.I have to tell ...

I have an assignment on kinematic chains.I have to tell the type of chain whether it is locked,constrained or unconstrained?? I am facing problem in counting number of joints,pair

Induction pressure welding, Induction Pressure Welding In this process,...

Induction Pressure Welding In this process, the current is induced by high frequency induction process in the job. Due to electrical induction the job is heated. When a suitabl

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd