Heat dissipation -various factors in clutch design , Mechanical Engineering

Heat Dissipation : During clutch application, large amount of heat is generated. The rubbing surfaces should have sufficient area and mass to absorb the generated heat. The proper design of the clutch should ensure proper ventilation or cooling for adequate dissipation of heat.

Related Discussions:- Heat dissipation -various factors in clutch design

Counterclockwise direction, Figure presents a gearbox that you are going to...

Figure presents a gearbox that you are going to design. The input shaft rotates at n1= 1500 rpm in a counterclockwise direction. The gearbox is needed to be designed sothat the out

Steps involved for method of section, Step s Involved for Method of Sectio...

Step s Involved for Method of Section: The different steps involved are stated below: (1) First find out support reaction by using equilibrium conditions. (2) The truss

Electrodes- inconel electrodes, Inconel Electrodes These electrodes are u...

Inconel Electrodes These electrodes are used in the industries, like petrochemical, fertiliser, etc. The weld composition contain small percentage of alloying elements like V, Mo

Explain about the deep foundation, Explain about the Deep foundation D...

Explain about the Deep foundation Deep foundations are those where the depth D is much larger than B. Piles, wells, piers and caissons belong to this group.

Mechine element and design, what is structure with example

what is structure with example

Engineering thermodynamics, how to prove that heat and work is path functio...

how to prove that heat and work is path function

Find out the modulus of elasticity, Find out the modulus of elasticity: ...

Find out the modulus of elasticity: A unidirectional FRP is produced with fibre volume ratio of 60%. The density of fibre is 1480 kg/m 3 and that of matrix is 1200 kg/m 3 . C

Find the maximum torque - i-section, Find the maximum torque - I-section: ...

Find the maximum torque - I-section: An I-section 150 × 80 mm has flanges 6 mm thick and web 4 mm thick. Discover the maximum torque that may be safely applied if the shear st

Determine the heat addition, Describe carburetion. What are the basic diffe...

Describe carburetion. What are the basic different air-fuel mixture on which an engine can be operated ? Write a short note on sterling cycle. In an engine working on inlet pres

Quenching and tempering, Quenching and Tempering Cast iron pearlite st...

Quenching and Tempering Cast iron pearlite structure might be heated to lower critical temperature and after that quenched to effect extremely rapid cooling. This treatment re

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages