Hazardous waste and material standards, Mechanical Engineering

Assignment Help:

Hazardous Waste and Material Standards

  • Each hazardous site must be examined and evaluated for its characteristics before workers are allowed entry. This will pre decide antihazard method and procedure.
  • Prior training on specific hazardous material must always be undertaken.
  • Besides engineering controls to restrict exposure risk the workers must use personal protective gear and equipment.
  • A site control programme must identify zonal plan, communication point, and station for medical assistance. Out of several inculcated work habits in hazardous environment teamwork must take precedence.
  • Periodical medical examination of workers handling hazardous
  • Waste material is required to be arranged.
  • The workers leaving the hazard filled space must follow decontamination procedure.
  • There must be contingency plans to deal with emergency situation in which coordination of all concerned department of the company and any outside agency must be ensured.
  • Air monitoring to measure hazardous material must be a routine practice.
  • The identities including names, official position and specialization of key personnel must be widely publicized among the workers dealing with such materials and situation.

Related Discussions:- Hazardous waste and material standards

Clutch in motorcycle, Clutch: Clutch is a part which is used to transmit t...

Clutch: Clutch is a part which is used to transmit the rotary motion of one shaft to another shaft, when desired; the axis of second shaft must be in line with the axis of the fir

Calculate value of cutting speed, a) A carbide tool with mild steel work pi...

a) A carbide tool with mild steel work piece was found to give life of 2hours while cutting at 50 mpm. Calculate the tool life if the same tool is used at a speed 25% higher than p

Milling, I need chart for speed/feed/depth of cut for general milling

I need chart for speed/feed/depth of cut for general milling

Creep, Creep in belt drive

Creep in belt drive

CAMS, COMPARISON WITH CAM MECHANISMS WITH LINKAGES

COMPARISON WITH CAM MECHANISMS WITH LINKAGES

Fluid friction, Fluid Friction: Fluid friction manifests when the lubr...

Fluid Friction: Fluid friction manifests when the lubricating fluid is introduced between contact surfaces of the two bodies. If thickness of lubricant or oil between the m

Define the advantages of electro discharge machining, Define the Advantages...

Define the Advantages of Electro discharge machining 1. The surface finish obtained is very good. 2. This process can be used for any hard material. 3. Materials likes ca

Engine misfires motorcycle problem, If Engine Misfires Cau...

If Engine Misfires Causes of Problem Remedy Incorrect Electrode gap of spark plug Electrode worn out Foule

Dryness fraction, how do you differentiate between wet steam and dry steam?...

how do you differentiate between wet steam and dry steam?

Frictional force acting on the ladder, Frictional force acting on the ladde...

Frictional force acting on the ladder: A uniform ladder having length 13m and weighing 250N is placed against smooth vertical wall with its lower end 5m from wall. The coeffi

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd