Grinding and brushing, Mechanical Engineering

Assignment Help:

Grinding & Brushing:

Grinding is process there has an abrasive wheel that rotating at certain speed to smooth a surface or to give an even finish on material. In this Blade production, we are using this special design grinding machine to grind the blade tips in order to meet the requirement surface angle for a functional purpose.

 This functional purpose can increase the sharpness of the blade tips due to the desire of our product. Once this grinding process done, it will cause a lot of burrs. According to our previously process, we will have brushing system to remove all the burrs on blades after grinding.

Brushing is almost similar with grinding process. As we used very fine brush to fin off the blade tips. The outcome was acceptable if we use naked eye to inspect. All the bigger burrs are perfectly able to be removed by using brushing process.


Related Discussions:- Grinding and brushing

Press tools, Difference between press forminig and hammer forming

Difference between press forminig and hammer forming

Determine the width and depth of the beam, Determine the width and depth of...

Determine the width and depth of the beam: A timber beam of rectangular section is only supported over a span of 5 m. It carries an uniformly distributed load of 15 kN/m over

Find out maximum bending stress induced in beam, Q. A beam made of C.I. hav...

Q. A beam made of C.I. having section of 50mm external diameter and 25 mm internal diameter is supported at 2 points 4 m apart. The beam carries concentrated load of 100N at the ce

Magnetic alloy steels, Magnetic Alloy Steels: These steels are divide...

Magnetic Alloy Steels: These steels are divided into two sets. Such which retain their magnetism and that which do not. The steels which retain their magnetism are termed as

Explain working of steam sampling, Q. Explain working of Steam Sampling? ...

Q. Explain working of Steam Sampling? Sample coolers shall be supplied by the Vendor. A common sample spillage trough shall also be provided by the Vendor, with a cover screen

Illustrate types of pipe racks, Q. Illustrate types of pipe racks? The ...

Q. Illustrate types of pipe racks? The following types of pipe racks may be required: • Interconnecting pipe rack (elevated). • Unit pipe rack (elevated). • Pipe ra

Stress analysis requirements, Q. Stress analysis requirements? All othe...

Q. Stress analysis requirements? All other lines requiring review by the stress group are to be checked for adequate support, stability, excessive movement, etc. Where hand ca

Violation of clausius statement - thermodynamics, Equivalen t of Kelvin Pl...

Equivalen t of Kelvin Plank and Clausius statement: The Kelvin plank and clausius statements of the second law and are equivalent in all the respect. The equivalence of state

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd