General purpose registers, Electrical Engineering

Assignment Help:

General  Purpose  Registers

Registers B, C ,D, E H , and L   are 8 bit  general  purpose  registers. These  registers store  8 bit  data  temporarily  for processing.

Some  time it  required to store  16 bit  data. In 8085 microprocessor BC, DE, and HL  are used  as register  pairs to store  16 bit data.

Hence  there are 6 general  purpose 8 bit  registers and they  can be  3 pairs as 16 bits registers.


Related Discussions:- General purpose registers

List the addressing modes supported by 8051, List the addressing modes supp...

List the addressing modes supported by 8051. 1. Register addressing  2. Direct  addressing 3. Register indirect addressing 4. Immediate addressing 5.Register addres

What is a positive clipper and explain its working, Q. What is a positive c...

Q. What is a positive clipper? Explain its action with the help of a circuit. A positive clipper is the circuit which is used to cut off the positive half cycle. The circuit wi

., ABOUT ASSIGNMENT ON MAGNETIC INDUCTION NEAR A LONG WIRE

ABOUT ASSIGNMENT ON MAGNETIC INDUCTION NEAR A LONG WIRE

Drain characteristics of fet, Q. In The Drain Characteristics Of FET What D...

Q. In The Drain Characteristics Of FET What Does The Region At Pinch Off? Field Effect Transistors (FETs) utilize a conductive channel whose resistance is controlled by an appl

Find the turns ratio, Q A60-Hz, 100-kVA, 2400/240-V(rms) transformer is use...

Q A60-Hz, 100-kVA, 2400/240-V(rms) transformer is used as a step-down transformer from a transmission line to a distribution system. Consider the transformer to be ideal. (a) Fi

Dual trace and dual beam cro, what is difference between dual trace and dua...

what is difference between dual trace and dual beam cro?

Determine the current in the circuit and the voltage, Q. Two identical junc...

Q. Two identical junction diodes whose volt-ampere relation is given by Equation in which I S = 0.1 µA, V T = 25 mV, and η = 2, are connected as shown in Figure. Determine the cu

Minimum value of rl that can be used, Verify the minimum & maximum load cur...

Verify the minimum & maximum load current for which the zener diode will keep regulation. Find the minimum value of RL that can be used. The zener diode has V Z = 12V, I ZK =

Define byte assembler directive, What do you understand by DB assembler...

What do you understand by DB assembler directive?   DB (Define Byte): The DB directive explains by a byte-type variable (that is a variable that occupies one byte of memo

Different types and uses of delay line in cro, Q.   What are the different ...

Q.   What are the different types and uses of delay line in CRO? OR Why is a delay line used in the vertical section of the oscilloscope? Sol. All electronic circui

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd