Find the rate of information transmission, Electrical Engineering

Assignment Help:

Q. Find the rate of information transmission?

If the time occupied in transmitting each binary digit is 1 µs, find the rate of information transmission if 1 baud is equal to 1 bit per second (bit/s).

Solution

Since the time per digit is 1 × 10-6 s, one can transmit 106 digits per second. The information rate is then 1×106 bits, or 1 megabaud (M baud). Note that speeds of over 100 M baud are quite possible.


Related Discussions:- Find the rate of information transmission

Explain negative test cases for testing mobile phones, Negative test cases...

Negative test cases for testing mobile phones are: 1.taking out the SIM card and made a call  2. by invalid phone number 3. Made a call at which there is no tower signa

Find the core radius necessary for a single mode operation, Find the core r...

Find the core radius necessary for a single mode operation at 1320nm of a step index fibre with n 1 =1.48 and n 2 =1.478. What are the N.A and maximum acceptance angle for this fib

Determine rc and resistance, Q. A silicon npn BJT is biased by the method s...

Q. A silicon npn BJT is biased by the method shown in Figure, with R E = 240 , R 2 = 3000 , and V CC = 24 V. The operating point corresponds to V BEQ = 0.8V, I BQ = 110 µA,

Inverter, single phase voltage source inverter complete circuit

single phase voltage source inverter complete circuit

Give a brief description of integrating circuits, Q. Give a brief descripti...

Q. Give a brief description of integrating circuits ? Integration is a summation of area. An integrating circuit produces an output voltage which is proportional to the area en

Working of self - excited generators, Q. Working of self - excited generato...

Q. Working of self - excited generators? For self-excited generators, residual magnetism must be present in the ferromagnetic circuit of the machine in order to start the self-

Disadvantages of software defined radio, Disadvantages of SDR 1. Power ...

Disadvantages of SDR 1. Power consumption is more due to rapid switching of modes 2. Hardware design is not easy 3. Software bugs exist in the system

Calculate the induced voltage at full load, A 100-kW, 230-V shunt generator...

A 100-kW, 230-V shunt generator has R a = 0.05  and R f = 57.5 . If the generator operates at rated voltage, calculate the induced voltage at (a) full load, and (b) one-half fu

Find the secondary and leakage path flux densities , Questions: A magne...

Questions: A magnetic core with a primary winding with 40 turns and a secondary winding with 80 turns has a leakage path dominated by an air gap as shown in the figure. The iro

Show step-motor control system, Q. Show Step-motor control system? Figu...

Q. Show Step-motor control system? Figure illustrates a system in which the prime mover used in the disk-drive system is a step motor driven by pulse commands. In response to e

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd