Find the maximum allowable size of the milling cutter, Mechanical Engineering

Assignment Help:

Find the Maximum Allowable Size of the Milling Cutter

Find the maximum allowable size of the milling cutter if it is to rotate at 65 rpm while the cutting speed is 20 m/min.

Solution

V_c = 20 m/min

N = 65 rpm

We know

V c = π DN/1000 m/min

D = V_c × 1000 / π N = 20 × 1000/ π × 65 = 98 mm

Related Discussions:- Find the maximum allowable size of the milling cutter

Explain streak line and stream function, Describe the following key terms: ...

Describe the following key terms: (i) Stream Line (ii) Path Line (iii) Streak Line (iv) Stream Function (v) Potential flow function (vi) Flow net

Design of connecting rod, Design of Connecting Rod: Design and analyse...

Design of Connecting Rod: Design and analyse the stress distribution in a connecting rod as shown in Figure 5. The axial load which the connecting rod carries is 1kN and the m

Perform a beam analysis, You need to sketch shear force and bending moment ...

You need to sketch shear force and bending moment diagrams and estimate maximum bending and shear stresses acting on the beam using your knowledge in beam analysis. Please note

Maximum slope and maximum deflection, Maximum slope and maximum deflection:...

Maximum slope and maximum deflection: A simply supported beam of span l is subjected to two concentrated loads at one-third span through two supports. Discover the maximum slo

Stress, Difference between direct and shear stress

Difference between direct and shear stress

Performance criteria-aspects of scheduling , Performance Criteria This ...

Performance Criteria This is assumed that an FMS is the part of a superior production process. Consequently the performance of the FMS is not a major goal but imply to attain c

Vacuum tube oscillator, i am try to make a vacuum tube oscillator for a lar...

i am try to make a vacuum tube oscillator for a larger project but i need help where to find the supplies for it where can i find them

Ratio of applied stress, Ratio of applied stress: What should be the r...

Ratio of applied stress: What should be the ratio of applied stress, s, to yield stress s Y in a large thin plate so that plastic spread along lint of crack is equal to 1 /1

Preliminary layout considerations, Q. Preliminary layout considerations? ...

Q. Preliminary layout considerations? This section outlines the key aspects to be considered when preparing preliminary layouts during the evaluate phase. Preliminary layouts a

Standard factory formed insulation on flanges and valves, Q. Standard facto...

Q. Standard factory formed insulation on Flanges and Valves? All fittings are to be insulated with standard factory formed insulation. All joints shall be buttered and sealed.

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages