Explain the per-action modeof QTP, Software Engineering

Assignment Help:

Explain the Per-action modeof QTP

- Best used in below cases:

- When creating simple record and run tests when there is just one or very few tests which correspond to interface, objects or application

- When test object properties will not be modified every now and then

- When creating single-action tests.

 

 


Related Discussions:- Explain the per-action modeof QTP

What is continuous cmmi model, What is continuous CMMI MODEL? This is a...

What is continuous CMMI MODEL? This is a finer-grain model that considers individual or groups of practices and assesses their use. The maturity assessment is not a one valu

Write the definition of design process, Write the definition of design proc...

Write the definition of design process. Design process is a sequence of steps carried by which the requirements are transformed into a system or software model.

Which phase is not available in software life cycle, Which phase is not ava...

Which phase is not available in software life cycle? Abstraction is the only phase which in not available in software life cycle

Time line chart, what is time line chart for travel management?

what is time line chart for travel management?

What are the objectives of analysis modelling, What are the objectives of A...

What are the objectives of Analysis modelling? i. To explain what the customer requires. ii. To establish a basis for the creation of software design. iii. To devise a se

List any characteristics of a good srs, List any three characteristics of a...

List any three characteristics of a good SRS. Ans:The SRS should be: Correct , Unambiguous, Complete 1. Correct: An SRS is correct if each requirement stated therein is on

What are the various level of testing, Testing is a process of implementing...

Testing is a process of implementing a program with the intent of finding an error. Various level of testing are :    Unit Testing     Integrating testing     Valida

Distinguish between verification and validation, Distinguish between verifi...

Distinguish between verification and validation. Verification refers to the set of activities that make sure that software correctly executes a specific function. Validation re

Draw a memory map for a system, Draw a memory map for a system with a memor...

Draw a memory map for a system with a memory capacity of 256MB. Each memory location in the system is 8 bits. Assume the system has one 4 MB memory block used as ROM residing at th

Develop a software architecture, Develop a software architecture for the Ca...

Develop a software architecture for the Case Study.   a. Identify the major 'design forces' () affecting the system, and discuss the 'architectural response' you think most   ap

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd