Explain open loop control systems, Electrical Engineering

Assignment Help:

Explain Open Loop Control Systems

In an open-loop control system, the controller independently computes exact voltage or current required by the actuator to do the job and sends it. Though, with this approach, the controller never in fact knows if the actuator did what it was supposed to as there is no feedback. This system absolutely relies on the controller knowing the operating characteristics of the actuator.


Related Discussions:- Explain open loop control systems

Draw a centralized spc organization, Q. Draw a centralized SPC organization...

Q. Draw a centralized SPC organization. Ans: A dual processor architecture can be configured to operate in one of three modes: (i)  Standby mode (ii)  Synchronous dupl

Schottky diodes - types of power diodes , Schottky  diodes The schot...

Schottky  diodes The schottky diodes have very fast recovery time and  low forward drop.  The current  ratings of  these diodes  vary  from 1A to 300 a and  maximum  allowable

Excess3 to bcd code converter using nand gates, design a excess3 to bcd cod...

design a excess3 to bcd code converter using only nand gates

Multitasking - single processor many users many tasks , Multitasking -  Si...

Multitasking -  Single Processor Many Users Many  Tasks In multitasking or also  called  time sharing  systems  multi  user  more than  one users are sharing  one processor

Amplifier, what is one common applicable for CB amplifier

what is one common applicable for CB amplifier

Earth leakage-earthing, Earth Leakage : Earth leakage takes place when, th...

Earth Leakage : Earth leakage takes place when, through some fault in an appliance or its connections. Electric current escapes to earth i.e. the body of the appliance become 'liv

Determine the full load voltage regulation, A 3 phase 60 hertz induction m...

A 3 phase 60 hertz induction motor has 8 poles and operates with a slip of .05 for a certain load. Compute in r.p.m. the (a)speed of the rotor with respect to the stator, (b)spe

Develop a two-dimensional addressing system, Q. Suppose a ROM holds a total...

Q. Suppose a ROM holds a total of 8192 bits. (a) How many bits long would the individual addresses have to be? (b) If the bits are organized into 8-bit memory words or bytes,

Telecommunication, Design a low noise amplifier using an Infineon RF transi...

Design a low noise amplifier using an Infineon RF transistor BFP640. The amplifier is to be used to amplify the L2 GPS signal and so the centre frequency is 1227MHz and bandwidth 4

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd