Explain in brief about the term - anchorage, Civil Engineering

Assignment Help:

Explain brief about the term - Anchorage

A device used to anchor tendons at the end of a concrete member is called as an anchorage in the case of post-tensioned concrete. In the case of a pre-tensioned concrete member, an anchorage is a device used to anchor stretched tendons during hardening of concrete.

Related Discussions:- Explain in brief about the term - anchorage

Rolling - binder, Rolling - Binder: The layer thickness is 40-50 mm. R...

Rolling - Binder: The layer thickness is 40-50 mm. Rolling is done in three stages : Initial Rolling By 80-100 kN smooth wheeled roller. Intermediate Rolling B

Non uniform flow in open channel, #ques5. A rectangular channel is 3 m in w...

#ques5. A rectangular channel is 3 m in width and draws water from a lake. The channel slope is 0.001 and the Manning’s n is 0.0013. What will be the discharge in the channel when

Deflection of beams, 1) A propped cantilever beam ABC is 7m long.It has th...

1) A propped cantilever beam ABC is 7m long.It has the point C fixed and Point A on a roller support.It carries a 200Kn point load at a distance 3m from A.There is a moment of 80KN

Determine the total head and total pressure of water, Determine the total h...

Determine the total head and total pressure of water flowing at in a pipe which has the following data: Flow= 2,500 gpm; Elevation = 30 ft; Pressure = 40 psi; Pipe Diameter =

Trusses design, does the truss pitch relate to the building''s height?

does the truss pitch relate to the building''s height?

Buildin construction, methods of damp proofing

methods of damp proofing

Explain the national primary drinking water standards, Explain the National...

Explain the National Primary Drinking Water Standards Safe Drinking Water Act (SDWA, 1974) required EPA to establish maximum contaminant levels (MCLs) for public water systems

Basic Structural Design, A flitched beam consists of a wooden joist 150 mm ...

A flitched beam consists of a wooden joist 150 mm wide and 300 mm deep strengthened by steel plates 12 mm thick and 300 mm deep one on either side of the joist. If the maximum st

Main purpose of conducting load test for piling works, Question What is...

Question What is main purpose of conducting load test for piling works ? Answer Pile load test gives information on ultimate bearing ability but not settlement be

Draw the shape of the pressure line, Draw the shape of the Pressure line. ...

Draw the shape of the Pressure line. Solution The locations of resultant force at sections A-A, B-B and C-C have already been determined. Joining these locations, we can dr

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages