Explain cutting speed - cutting parameters, Mechanical Engineering

Assignment Help:

Explain Cutting Speed - Cutting Parameters

  • It is relative speed (V1) between wheel and the Work piece.
  • It is expressed in m/sec.

 

V=Cutting speed=V1 

=πDN1/1000 × 60

Where D=Diameter of grinding wheel in mm.

N1=Speed of wheel in R.P.M.


Related Discussions:- Explain cutting speed - cutting parameters

General construction procedure of foundation, General Construction Procedur...

General Construction Procedure Well foundations may be constructed in slipways on barges, or on sand islands. The ones constructed in slipways are launched and towed to their

Mechanical design of the blowdown systems, Q. Mechanical design of the blow...

Q. Mechanical design of the blowdown systems? Mechanical design of the blowdown systems shall be sized for a continuous blowdown of a minimum of 1.0% of MCR. Fabricator may re

Type of strain, Type of strain: There are basically four type of strai...

Type of strain: There are basically four type of strain 1. Tensile strain 2. Compressive strain 3. Volumetric strain 4. Shear strain

Define carbon steel, Q. Define Carbon steel? At ambient temperatures an...

Q. Define Carbon steel? At ambient temperatures and under dry conditions, caustic is not particularly corrosive and can be handled in carbon steel. However, stress corrosion c

Breather tube-stator plate oil seal complaints, Breather tube : Check brea...

Breather tube : Check breather tube for blockage and also air filter box hole where breather tube is connected, for any blockage.

Co2 moulding, more about the carbon dioxide(co2) moulding process,for my se...

more about the carbon dioxide(co2) moulding process,for my seminar topic.

How will you measure the engine oil level?, (a) Why do we change the engine...

(a) Why do we change the engine oil at periodic intervals? (b) What are the recommended instructions to change engine oil? (c) How will you measure the engine oil level?

Relation between stress and strain, Relation between stress and strain: ...

Relation between stress and strain: The relation between stress and strain is generally shown by plotting a stress-strain (σ -e) diagram. Stress can be plotted on ordinate (ve

Natural air cooling- type of cooling system, Natural Air Cooling: The...

Natural Air Cooling: The strips like extensions (fins) are integrated on the outside of the cylinder and cylinder block. These fins are designed in such a way that they can t

Determine the maximum hoop - conical shells, Determine the maximum hoop: ...

Determine the maximum hoop: A conical water tank of height 2 metres & base radius 500 mm is supported at top and is full of water. The thickness of the wall is refer to 24 mm,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd