Explain branch prediction logic in pentium, Electrical Engineering

Assignment Help:

Explain Branch prediction logic in Pentium.

Branch prediction logic in Pentium: The Pentium microprocessor utilizes branch prediction logic to decrease the time needed for a branch caused by internal delays. Such delays are minimized since when a branch instruction is encountered therefore the microprocessor begins pre-fetch instruction at the branch address. These instructions are loaded in the instruction cache, therefore when the branch arises; the instructions are present and permit the branch to execute in one clocking period. The branch needs an extra three clocking periods to execute, if for any reason the branch prediction logic errors. In most cases, the branch prediction is right and no delay ensues.


Related Discussions:- Explain branch prediction logic in pentium

Differentiate between a clamper and clipper, Q. What is a clamper? Differen...

Q. What is a clamper? Differentiate between a clamper and clipper. Clamping network shifts (clamps) a signal to a different dc level, i.e. it introduces a dc level to an ac sig

Current flow through the channel of a jfet after pinch off, Q. How does cur...

Q. How does current flow through the channel of a JFET after pinch off? It is seen that above the pinch off voltage at a constant value of VDS (saturation drain current, ID inc

Construction of a two stage rc coupled amplifier, Q. Describe the construct...

Q. Describe the construction of a two stage RC coupled amplifier with diagram. A cascaded arrangement of common-emitter transistor stages is shown above. The output Y1 of

Superposition theorem, what is the disadvantages of superposition theorem?

what is the disadvantages of superposition theorem?

Why are waveguides not used at low frequencies, Q. Comment brie?y on the fo...

Q. Comment brie?y on the following: (a) Why are waveguides not used at low frequencies? (b) Why are open-wire lines not generally used as guiding structures at very high freq

Determine what is the minimum required sampling rate, 1. An analog informat...

1. An analog information signal, whose maximum frequency is 6000Hz, is to be transmitted using a PCM system. The quantization error must not exceed the 1 % of the peak-to- peak an

Digital switching switching in telecommunication, Name the switching scheme...

Name the switching schemes used in a digital exchange

Describe watch dog timer and reaction timer, a. Given a timer with a termin...

a. Given a timer with a terminal count and a clock frequency of 10 MHz measure the following: (i) Range & Resolution (ii) Terminal count values needed to measure 3ms interval

Gate source cut off voltage, Q. Gate source cut off voltage? It is the ...

Q. Gate source cut off voltage? It is the gate source voltage where the channel is completely cut off and the drain current becomes zero.It is interesting to note that the valu

PIC Controller Programming, I want to do programming in PIC controller and ...

I want to do programming in PIC controller and it needs to be done on particular development board.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd