Exhaust section inspection of aircraft, Other Engineering

Assignment Help:

Exhaust Section Inspection.

Inspection of the exhaust section of the engine can be done visually using an appropriate light source. The exhaust cone and jet pipe are examined for signs of cracking, warping, buckling or hot spots. Hot spots identified on the exhaust cone may be the result of a defective fuel nozzle or combustion chamber resulting in the requirement for further investigation.

1773_Exhaust Section Inspection.png


Related Discussions:- Exhaust section inspection of aircraft

Layout and operation of typical thrust reversing system, Layout and operati...

Layout and operation of typical thrust reversing system: Clamshell door system The clamshell door system is a pneumatically operated system, as shown in detail in fig Norm

Damping coefficint of canatrd of aircraft, what will be the methodology to ...

what will be the methodology to calculate pitching moment damping coefficient of canrad of aircraft

Thermodynamics.., Steam enters in the turbine at 6 MPa and 450 deg C and ex...

Steam enters in the turbine at 6 MPa and 450 deg C and expands at some intermediate pressure 60 % of steam is extracted and remainder expands to 10 kPa at this Investigate the effe

What is networth?, What is Networth? Networth is the complete resources ...

What is Networth? Networth is the complete resources without complete obligations of an organization. Networth means equity and it is the present resources without present oblig

Basic electronics, Q 1.what is the difference between BJT and FET.What is B...

Q 1.what is the difference between BJT and FET.What is Biasing?Discuss abt diffrent Biasing techniques?Write the advantages and Volatage divider biasing over other biasing?what is

Climbing drum peel test , Climbing Drum Peel Test The CDP test works by a...

Climbing Drum Peel Test The CDP test works by attaching a free end of a face sheet of a sandwich panel to a drum which then rolls across the panel, peeling off the face sheet. A

Finance, Rajender Kumar was a production worker at competent Motors Limited...

Rajender Kumar was a production worker at competent Motors Limited (CML) which made components and accessories for the automotive industry. He had worked at CML for almost seven ye

Material used for patterns, Material Used for Patterns : The common materi...

Material Used for Patterns : The common materials of which the patterns are made of the following :             1. Wood: The common woods are :             (i)   Pine

Changes in temperature and pressure-aircraft maintenance, Changes in temper...

Changes in temperature and pressure: The changes in temperature and pressure of the gases through a gas turbine engine are illustrated in Figure 1.5 The efficiency with which t

Aeroengines - compressible flow, All fluids are to some extent compressible...

All fluids are to some extent compressible but gases show significant changes in density if pressure and/or temperature is changed. Some gas flows can be treated as being incomp

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd