Example register to memory , Electrical Engineering

Assignment Help:

Example  Register  to Memory

Example : Write assembly language  statement  to copy 25H  stored  in register D to memory location 3052H.

Solution :  Assuming  3050H is sorted  in register pair HL and 25H  is stored  in register D  the statement is

 MOV M D

Content of  register  D   are copied  to memory  location pointed by HL  register  pair.


Related Discussions:- Example register to memory

What is trans conductance, Q. What is Trans conductance? It is ratio of...

Q. What is Trans conductance? It is ratio of small change in drain current to the corresponding change in the gate-to-source voltage for a constant gate-to-source voltage .it i

Miller sweep circuit, explain the working of miller sweep circuit using op ...

explain the working of miller sweep circuit using op amp ic

Biasing the bjt, Q. Biasing the BJT? A simple method of biasing the BJT...

Q. Biasing the BJT? A simple method of biasing the BJT is shown in Figure. While no general biasing procedure that will work in all cases can be outlined, a reasonable approach

Transistors, what is transistor how it works?

what is transistor how it works?

What is peripheral component interconnect, What is a PCI bus? Periphera...

What is a PCI bus? Peripheral Component Interconnect: PCI bus was developed through Intel and introduced in 1993. This is geared specifically to fifth- and sixth-generation sys

Superposition theorem, what is the disadvantages of superposition theorem?

what is the disadvantages of superposition theorem?

Determine the armature current of synchronous generators, Two three-phase, ...

Two three-phase, 6.6-kV, wye-connected synchronous generators, operating in parallel, supply a load of 3000 kWat 0.8 power factor lagging. The synchronous impedance per phase ofmac

Explain the terms dielectric constant and dielectric loss, Explain the term...

Explain the terms dielectric constant and dielectric loss. Dielectric Constant or Permittivity: all insulating materials possess an electrical capacitance. The capacitance of

Active filter design, Design a wide band pass filter with cut-off frequency...

Design a wide band pass filter with cut-off frequency f L = 400 kHz, f H = 600 kHz, and a pass-band gain = 10. The roll-off rate at the cut-off frequency should be at least 4

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd