Evaluate the voltage gain, Electrical Engineering

Assignment Help:

Q. On a CD amplifier Rs = 4k?, µ =50 and r =35k?. Evaluate the voltage gain Av.

Av = Vo/Vi = µRs / (µ+1)Rs + r
                                 
                                           =  50×4×10^3 / ((50+1)×4×10^3) + (35×10^3)

                                           = 0.836

The positive value indicates that the voltages Vo and Vi are in phase and further note that Av < 1, for CD amplifier.


Related Discussions:- Evaluate the voltage gain

State thevenin'' s theorem, Thevenin' s Theorem Thevenins Theorem state...

Thevenin' s Theorem Thevenins Theorem states: "Any linear circuit containing several energy source and resistances can be replaced by just a Single Voltage in series with a

Find the line current after the addition of capacitor bank, Q. Find the lin...

Q. Find the line current after the addition of capacitor bank? A 60-Hz, three-phase motor draws 25 kVA at 0.707 lagging power factor from a 220-V source. It is desired to impro

Determine the location and the value of the point charge, Q The electric ?e...

Q The electric ?eld intensity due to a point charge in free space is given to be (-¯ ax -¯ ay +¯ az)/√ 12V/mat (0,0,1) and 6 ¯ az at (2,2,0) Determine the location and the value

A circuit having of a resistor connected in series, A circuit having of a r...

A circuit having of a resistor connected in series with a 0.5µF capacitor and has a time constant of 12 ms. Verify: (a)  The value of the resistor (b)  The capacitor voltage

Show limitations of microprocessor-based control systems, Q. Show limitatio...

Q. Show limitations of microprocessor-based control systems? Practical limitations of microprocessor-based control systems stem from the following considerations: • Finite-w

Transparent latch d flip flop, Transparent latch D flip  Flop A typica...

Transparent latch D flip  Flop A typical  example  of this  type of D flop  is 7475 shown  in figure when CLK  connected is enable signal is high and the flip  flop  is enabled

What is the use of 8251 chip, What is the use of 8251 chip? 8251 chip i...

What is the use of 8251 chip? 8251 chip is mostly used as the asynchronous serial interface among the processor and the external equipment.

Working of field-effect transistors, Q. Working of Field-effect transistors...

Q. Working of Field-effect transistors? Field-effect transistors (FETs) may be classified as JFETs (junction field-effect transistors), depletion MOSFETs (metal-oxide-semicondu

Neutral line in transformer, thus secondary winding of transformer consists...

thus secondary winding of transformer consists of neutral line or not?

Sketch the waveforms of sinusoidal voltage source, Q. Consider the op-amp c...

Q. Consider the op-amp circuit of Figure. Sketch the waveforms of v S and v o , if v S is a sinusoidal voltage source with a peak value of 2.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd