Estimate the hourly emissions - source emission factors, Chemical Engineering

Assignment Help:

A contaminated soil contains 100 mg metals/kg soil (all metals are readily condensable), 50,000 mg S/kg soil, 1,000 mg F/kg soil, 980 mg/Kg of VOCs and 40,000 mg Cl/kg soil and is to be decontaminated by using incineration.  The incinerator is operated at a heat loading of 63 MM Kilojoules/hour and has an estimated stack gas flow of 986 m3/minute.  The rate of feeding the soil into the incinerator will be 3,400 g/hour.  Using the EPA uncontrolled source emission factors given below, estimate the hourly emissions that would be expected in the flue gas of this incinerator if no air pollution control equipment were used (show all your calculations).

1182_Estimate the Hourly Emissions - Source Emission Factors.png

If pollution control equipment is installed to remove 95.5% of the PM and 99.96% of the VOC emissions, what would be the new hourly emissions in the flue gas?  Support your results with all assumptions that you must make.


Related Discussions:- Estimate the hourly emissions - source emission factors

Derive the ultimate primary controller gain, Consider the cascade loop as s...

Consider the cascade loop as shown below: i)   Specify the inner-loop gain such that the damping coefficient of the closed loop is equal to 0.4 ii)  Derive the ultimate

Find a rate expression for the reaction, Find a Rate Expression for the Rea...

Find a Rate Expression for the Reaction The saponification of the ester propargyl acetate, A, with base, B, was studied by Myers, Collett, and Lazzell using a conductivity tech

Explain the mechanism of ferromagnetism, Explain the mechanism of ferromagn...

Explain the mechanism of ferromagnetism Ferromagnetism is the basic mechanism by which certain materials (like iron) form permanent magnets and/or exhibit tough interactions

iron-carbon alloy , It is desired to generate an iron-carbon alloy that ha...

It is desired to generate an iron-carbon alloy that has a minimum hardness of 200 HB and a minimum ductility of 35%RA. Is such an alloy possible? If so, what will be its compositio

Explain the fluidized catalytic cracking method, 1. What are chemical fuels...

1. What are chemical fuels? How they are classified?  List the characteristics of a good fuel. 2. Define cracking. Explain the fluidized catalytic cracking method with neat diag

Water and Wastewater Treatment, this is my assignment '' Disinfection of wa...

this is my assignment '' Disinfection of water streams originating from potable water plants is key in protecting environmental health. Describe the process design and application,

Process description for production of chemicals from coal, Process Descript...

Process Description For Production of Chemicals from Coal Before it can be fed to the gasification reactor, coal must be ground to meet specifications on particle size. The gr

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd