Difference between an isotropic and othrotropic, Physics

Assignment Help:

1. What are multipoint constraints?

2. What is the difference between an RBE2 and RBE3? When is one use over the other?

3. What is the difference between an isotropic, othrotropic,  and anisotropic material?


Related Discussions:- Difference between an isotropic and othrotropic

Radiography and depletion of ozone layer, Radiography and depletion of Ozon...

Radiography and depletion of Ozone layer: What is Radiography?  A. The method in which soft X-rays are used in medical diagnosis is called radiography. What are the uses

Magnetism - basic concepts, Magnetism - Basic concepts: 1. Pole st...

Magnetism - Basic concepts: 1. Pole strength: The ability of a pole  of  a magnet to attract or repel another magnetic pole is called its pole strength. Units : A-m 2.

Energy, When does the Total mechanical energy remain constant?

When does the Total mechanical energy remain constant?

Other semiconductor materials, GALLIUM PHOSPIDE: It has band gap of 2.3e...

GALLIUM PHOSPIDE: It has band gap of 2.3ev. it can be used for light emitting diodes which can emit  green or red light. The red light is obtained with zinc or cadmium oxide dop

Huygens wave theory, Huygens wave theory: Huygen's wave theory is not c...

Huygens wave theory: Huygen's wave theory is not correct in all respects. 2. It assumes simply that light energy is propagated as a wave. 3. At the time of his proposition

Vibrational modes of carbon dioxide molecule representation, How are vibrat...

How are vibrational modes of carbon dioxide molecule represented? Generally the modes are represented through three integers (mnq): a. (moo) represents Symmetric stretching

Mercury is poured into a u-tube, Mercury is poured into a U-tube as shown i...

Mercury is poured into a U-tube as shown in Figure given below. 100g of water is then poured into the right hand side of the tube. The density of mercury is 13.6g/cm 3 . What heigh

Define doppler''s effect of light, The process of apparent change in freque...

The process of apparent change in frequency (or wavelength) of the light because of relative motion among the source of light and the observer is known as Doppler's effect.

Jet propulsion is made possible by action and reaction, Jet propulsion is m...

Jet propulsion is made possible by action and reaction Fit a small cardboard stabilizer to the neck of a balloon by means of adhesive tape. Inflate the balloon, and close the m

Determine the b-h curves, Figure  shows the magnetic circuit of a relay. ...

Figure  shows the magnetic circuit of a relay. When each of the air gaps are 1.5mm wide find the mmf required to produce a flux density of 0.75 T in the air gaps. Use the B-

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd