Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In Microprocessor more op-codes, few bit handling instructions. But in Microcontroller: fewer op-codes, more bit handling Instructions, and also it is described as a device that haves micro processor, memory, & input / output signal lines on a one chip.
The basic architectural difference is that microcontroller has an programmable memory whereas it is not the case with microprocessors.
Question: a). For the circuit shown in figure state which operation is performed and draw the output waveform if measured between points A and B. The input signal is given in f
Q. Draw the circuit of a 7805 voltage regulator? Explain the functions of the capacitors used at its input and output sides. Functions of capacitors used at input and outp
What is the purpose of control word written to control register in 8255? The control words written to control register state an I/O function for every I.O port. The bit D7 of t
What are operations performed on data in 8085 The various operations performed are Store 8-bit data Perform arithmetic and logical operations Test for conditio
Input Output Operations Many times microprocessor has to accept data from input port and send data to output port to interact with the real world. Input port is tri st
Externally Initiated Signals Other than interrupt there are followings externally initiated signals available in 8085 microprocessor.
A copper cylinder 40 cm diameter and 10 mm thick is nearly wound with a layer of 4mm diameter steel wire under a tensile stress of 80 Mpa. If the steam under a pressure of 5 Mpa is
Q. Write a short note on the frequency response of a R-C coupled amplifier. At low frequencies ( , the reactance of coupling capacitor Cc is quite high and hence very small pa
Provide Definition of Signals A continuous-time signal x(t) is a signal that is a function of real number t. For a discrete-time signal x[n], it is a method of discrete time in
Q The electric ?eld intensity due to a point charge in free space is given to be (-¯ ax -¯ ay +¯ az)/√ 12V/mat (0,0,1) and 6 ¯ az at (2,2,0) Determine the location and the value
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd