development of surfaces, Other Engineering

Assignment Help:
a hexagonal prism of 40mm side length of base and height 80mm is resting on HP on its base with two edges of base is parallel to horizontal plane. A square hall of equally inclined to HP and axis of square hall bisects the axis of prism. Draw development of surfaces of prism.

Related Discussions:- development of surfaces

Level indicator., i have a project to be completed, the project is, How to ...

i have a project to be completed, the project is, How to make a device which warns you when your water reservoir is full?? i want the name of device needed and the way to complete

Method of calculating the thrust forces-engine performance, Method of calcu...

Method of calculating the thrust forces: The thrust forces or gas loads can be calculated for the engine, or for any flow section of the engine, provided that the areas, pressu

Combustion section - aircraft engine, Combustion section: The combustio...

Combustion section: The combustion chamber has the difficult task of burning large quantities of fuel, supplied through the fuel burners, with extensive volumes of air, supplie

The compression after impact test, This Compression After Impact (CAI) test...

This Compression After Impact (CAI) test fixture was developed by the Boeing Company. The specimen, typically, but not necessarily, a quasi-isotropic laminate, is 6" long, 4" wide,

Engineering mechanics, a circular roller of radius 10cm and of weight 1.8kn...

a circular roller of radius 10cm and of weight 1.8kn rest on a smooth horizontal surface

Flight dynamics - introduction, In the Aircraft Performance course, the air...

In the Aircraft Performance course, the aircraft was assumed to be in a steady-state (e.g. steady  cruise, climb, turn, glide), with the forces and moments balanced. The subject of

Students industrial work experience, Where are the recomended areas or indu...

Where are the recomended areas or industries where an Agricultural Engineering Student can apply for industrial training?

Engine cycles, ENGINE CYCLES The two commonly used cycles on which th...

ENGINE CYCLES The two commonly used cycles on which the I.C. engines operate are: 1Otto cycle.         2 Diesel cycle. 1 OTTO CYCLE: theoretical Otto cycle is shown i

Flight control - state feedback, If all states are measured by appropriate ...

If all states are measured by appropriate sensors and interfaced to the flight control computer then allthe states may be fed back and there is no restriction on the choice of K. S

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd