Determine for water flow rate, Mechanical Engineering

Assignment Help:

A counter flow heat exchanger is used to cool 2000kg/hr of oil(Cp= 2.5 KJ/Kg K) from 105 oC to 30 oC by the use of water entering at 15 oC. If the overall heat transfer coefficient is approximate to be 1.5 Kw/m2K, make determination for water flow rate, the surface area needed and the effectiveness of heat exchanger. Presume that the exit temperature of the water is not to exceed 80 o C. Use NTU-effectiveness approach.


Related Discussions:- Determine for water flow rate

Crankshaft-basic components of engine , Crankshaft : It converts the recip...

Crankshaft : It converts the reciprocating motion of the piston into useful rotary motion. In the crankshaft of a single cylinder engine, there is a pair of crank arms and balance

What is the extension of screw conveyer, "Extension of screw conveyer by us...

"Extension of screw conveyer by using spline shaft, U-joint with the help of hydraulic cylinder" For fully automatic extension of screw conveyer according to screed width we ha

Centre of gravity and centroid, Q.   Explain the terms centre of gravity an...

Q.   Explain the terms centre of gravity and centroid. Sol. : A point can be found out in a body through which resultant of all such parallel forces acts. This point through

Hot service insluation thicknesses, Q. Hot Service Insluation Thicknesses? ...

Q. Hot Service Insluation Thicknesses? Hot Service Insluation Thicknesses are specified based on the following design criteria: • Average Annual Climatic Conditions:

Determine modulus of resilience, Determine modulus of resilience: A st...

Determine modulus of resilience: A steel specimen of 10 mm diameter & 50 mm gauge length was tested in tension and following observations were recorded. Load at upper yield

Land fill bio gas, working principle of land fill bio gas plant

working principle of land fill bio gas plant

Clutch free play-clutch complaints, Clutch free play : Check for free play ...

Clutch free play : Check for free play of the clutch lever. It should be within 10-20 mm.

Thermal Science, Write an essay on air, water and soil-based heat pumps. Di...

Write an essay on air, water and soil-based heat pumps. Discuss the advantages and the disadvantages of each system. For each system identify the conditions under which that system

Flash butt welding-flashing, Flash Butt Welding-Flashing The phenomenon...

Flash Butt Welding-Flashing The phenomenon of flashing is of extreme importance in achieving satisfactory welds. Flashing can begin only after a molten bridge has been formed s

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd