Determine about the statement - failure at cracking load, Civil Engineering

Assignment Help:

Determine about the statement - Failure at Cracking Load

This brittle mode of failure is likely to occur in those pre-stressed elements that are concentrically pre-stressed with small amounts of steel. In such cases, the cracking load may be higher than the ultimate load. This type of failure may occur in hollow or solid pre-stressed concrete elements with small amount of steel.

Related Discussions:- Determine about the statement - failure at cracking load

Assignment for marketing mix, Assignment for marketing mix

Assignment for marketing mix

Determine the water content of the sand sample, In order to determine the w...

In order to determine the water content of a wet sand, a sample weighing 4 N was put in a pyknometer. Water was then poured to fill it and the weight of the pyknometer and its con

Define concrete substruct - underwater inspection of bridges, Define Concre...

Define Concrete substruct - underwater inspection of bridges? Plain, reinforced, and pre-stressed concrete are used for construction of underwater elements. Since the majority

Local vehicle parapet strong enough to contain vehicles, Q. Local vehicle p...

Q. Local vehicle parapet strong enough to contain vehicles? Majority of local parapets are 1.1m high in addition they are designed to resist impact from a 1.5ton car moving at

Poly tetra fluoro ethylene (PTFE) is used in sliding bearing, Question W...

Question Why Poly tetra fluoro ethylene (PTFE) is usually used in sliding bearings? Answer The choice of sliding surface of bearings is of very important importance sinc

Supply each tremie pipe with a single concrete truck, Question Througho...

Question Throughout concreting of diaphragm walls , three tremie pipes are used in single time. But, only one concrete truck is obtainable. How have to concreting works been a

Evaluate different gas turbine engine, Investigate and evaluate different G...

Investigate and evaluate different Gas Turbine Engine configurations in use for commercial or military Gas Turbine Engine aircraft. 1) Through research, investigate the differen

Strength of materials, what are the different between stress and strain

what are the different between stress and strain

Road and traffic engineering(signal timing design), what are the basic assu...

what are the basic assumption of traffic flow model and capacity model used in signal timing design ? discuss

Convert reduced bearings into whole circle bearings, Example: Convert t...

Example: Convert the following reduced bearings into whole circle bearings: (i) N 65° E (ii) S 43° 15′ E (iii) S 52° 30′ W (iv)

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages