Determine 802.11a OFDM, Computer Networking

Assignment Help:

802.11a OFDM

a) Orthogonal frequency-division multiplexing utilizing a 5-GHz band

b) Same as FDM except all sub bands are used by only one source at a given time

c)  Security increased by assigning sub bands randomly

d)  Data rates of 18 Mbps and 54 Mbps

e)  Often used in power-line networking

#question..

 


Related Discussions:- Determine 802.11a OFDM

What is framing, What is Framing? Framing in the data link layer divide...

What is Framing? Framing in the data link layer divides a message from one source to a destination, or from other messages to other destinations, by adding a sender address and

What is bens network, Q. What is Bens Network? It's a non-blocking netw...

Q. What is Bens Network? It's a non-blocking network. It's a special type of Clos network where first and last stage consists of  2×2 switches (for n input  and m output networ

What is a jam signal, What is a jam signal A jam signal is broadcasts ...

What is a jam signal A jam signal is broadcasts to network by the transmitting stations that detected the collision to ensure that all stations know of the collision. Every st

Explain about the middleware support, Explain about the Middleware support ...

Explain about the Middleware support All the connectivity interface related tools come under the category of middleware. Middleware provides the link for data exchange between

What do you mean by auto-reconfiguration, What do you mean by Beaconing an...

What do you mean by Beaconing and Auto-Reconfiguration? When a station does not receive a message from its nearest active upstream neighbor, it sends out a warning, otherwise c

Causes of failures, CAUSES OF FAILURES Every failure has a well-define...

CAUSES OF FAILURES Every failure has a well-defined cause.  Any system or device has an inherent strength or capacity to resist failures. This depends on design, material, man

Bridges, BRIDGES:  A bridge is a hardware device also needed to connec...

BRIDGES:  A bridge is a hardware device also needed to connect two LAN code segments to extend a LAN. A bridge uses two NICs to connect two code segments. It listens to all tr

Why do we require a subnet mask? , If the host has the subnet ID why do we ...

If the host has the subnet ID why do we require a subnet mask?

Name the protocol which is networking middleware, Name the protocol which i...

Name the protocol which is networking middleware SOCKS is a networking middleware: a circuit-level gateway, acting as a proxy and is placed at the session layer to mediate clie

Error detection-general, Q. Error Detection-General? Sender transmi...

Q. Error Detection-General? Sender transmits every data unit twice Receiver performs bit-by-bit comparison between those two versions of data. Any mismatch would

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd