Describe about reduction clause, Electrical Engineering

Assignment Help:

Q. Describe about Reduction Clause?

Reduction clause specifies an operator as well as one or more list items. For every list item a private copy is created on every thread and is initialized suitably for operator. After the end of region original list item is updated with values of private copies employing specified operator. Syntax of reduction clause is as follows: 

reduction (operator:list)


Related Discussions:- Describe about reduction clause

Power and power distribution, design a single phase circuit from a supply p...

design a single phase circuit from a supply point to a load

Engine management systems for ic engines, In continuation of Part-B, the st...

In continuation of Part-B, the student is required to configure an engine management system for the proposed engine and produce a report including the following: A preamble

Permanent magnets, If a permanent magnet creates the flux in a magnetic cir...

If a permanent magnet creates the flux in a magnetic circuit, the flux exists without the need for a coil, so how does Amperes Law apply to this case?   In this case the flux is

Describe about transmission-line voltage regulation, Q. Describe about tran...

Q. Describe about transmission-line voltage regulation? The transmission-line voltage regulation (TLVR) is the ratio of the per-phase voltage drop between the sending-end and r

Lica, advantages of constant current bias

advantages of constant current bias

Determine the study of robotics, Determine the study of Robotics Robots...

Determine the study of Robotics Robots can comprise embedded processors or be linked to a computer system. They are pre-programmed to do a specific task or taught' to remember

Show the frequency response of rc coupled amplifier, Q. Show the Frequency ...

Q. Show the Frequency response of Rc Coupled Amplifier? 1. At low frequency i.e,less than 50 Hz reactance of Cc is going high hence same part of the signal will pass from one s

memory to register , Memory  to Register This  instruction is used to...

Memory  to Register This  instruction is used to copy the contents of a memory  locations whose  address is specified by the HL register  pair to any register. Before  using th

Carthode ray oscilloscope, with a simple circuit,explain the construction o...

with a simple circuit,explain the construction of Direct Reading Probe of a cathode ray oscilloscope

Impedance / DUTT, 3) The impedance for a 120 km, 230-kV line is given as j ...

3) The impedance for a 120 km, 230-kV line is given as j 0.9 ohm/km and j 0.6 ohm/km for self and mutual terms respectively; resistance is neglected. The mho characteristic for the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd