Define advantages of welding process, Mechanical Engineering

Assignment Help:

Advantages of welding process

Welding results in a good saving of material and reduced labour content of production.

Low manufacturing costs.
Dependability of the medium, that is, the weld men are safer.
It gives the designer great latitude in planning and designing.
Welding is also useful as a method for repairing broken, worn or defective metal parts.
Without welding techniques, the light weight methods of fabrication, so vital to the automotive and aircraft industries, would be unthinkable

Related Discussions:- Define advantages of welding process

Force required to start the roller, Force required to start the roller: ...

Force required to start the roller: A roller shown in the figure given below is of mass 150Kg. What force T is required to start the roller over block A ? Sol.: Let

QFD chart and engineering specifications, Deliverables: A QFD chart, sh...

Deliverables: A QFD chart, showing the relationships between the customer requirements and the engineering specifications. (Refer to the Ullman QFD chart posted on My

Flange assembly with torque measurement, Q. Flange Assembly with Torque Mea...

Q. Flange Assembly with Torque Measurement? Select the proper bolts and gasket for the intended service. Use only new, undamaged gaskets. Lubricate the bolt threads and nut

What is the net angle of twist at the free end, What is the net angle of tw...

What is the net angle of twist at the free end: The stepped steel shaft illustrated in Figure is subjected to a torque (T) at the free end and a torque (2T) in the opposite di

Determine the shape of the beam, Determine the shape of the beam: A si...

Determine the shape of the beam: A simply supported beam of span l carries a concentrated load P at midspan. If the beam is to be a beam of consistent strength, determine the

CAE & modelling, when is scaling transformation termed as linear

when is scaling transformation termed as linear

Orthogonal cutting test, In an orthogonal cutting test with a tool of rake ...

In an orthogonal cutting test with a tool of rake angle 10 degree , the following observations were made. 20 Chip thickness ratio = 0.3 Width of cut = 6mm Uncut chip thicknes

FEA, Simple 3 node triangle. need to find displacement and reaction loads

Simple 3 node triangle. need to find displacement and reaction loads

Industrial engineering and management, what is the effect of tolerance in p...

what is the effect of tolerance in process planning?

Flux cored arc welding, Flux Cored Arc Welding Single Pass F illet Weld...

Flux Cored Arc Welding Single Pass F illet Welds upto (8.0 mm) maximum and groove welds made with a single pass or a single pass each side, may be made using an E70T-X electrod

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages