Cpi compare immediate instruction , Electrical Engineering

Assignment Help:

CPI Compare Immediate Instruction

The 8 bit  data  specified  in the  instruction is  compared with the  contents of the accumulator. The comparison  is done by  subtracting  the 8 bit data form  the contents of the accumulator the  contents of the accumulator d not  change. The flags are modified similar  to subtraction. The instruction format is

CPI 8 bit data                    (A- 8bit data )

Flags : All  flags are modified as they would  change  in subtract operation but the  content of  both  the operand do no to change.

Although  all flags  are modified  but the  conclusion can be made only by CY and Z flag as shown  below .

IF A> 8 bit data CY and Z Flags are reset.

IF A =8 bit  data Z flag  is set and CY flag is reset.

IF A < 8 bit  CY is set and Z  flag is  reset.


Related Discussions:- Cpi compare immediate instruction

Can you explain about trapeziodal clippers, Q. Can you explain about Trapez...

Q. Can you explain about Trapeziodal Clippers? During The Positive half cycle, the diode D1 will be open circuited and the input appears as the output until, the applied bias v

Purpose of compensation and space charge neutrality, My question about abov...

My question about above topic is"what is the use of the of this process" why we do compensation and space charge carrier

Determine the maximum power, Determine the maximum power: 1 For the c...

Determine the maximum power: 1 For the circuit shown below, what value of RL will result in maximum power transfer? Determine the maximum power dissipated in RL. You

Calculate load current and terminal voltage of each machine, Q. The externa...

Q. The external - characteristics data of two shunt generators in parallel are given as follows: Load Current, A: 0 5 10 15 20 25 30 Terminal voltage I, V: 270 263 254 240 22

Explain about subscriber loop system, Q. Explain about Subscriber Loop Syst...

Q. Explain about Subscriber Loop System? Subscriber Loop System:Each subscriber in a telephone network is connected normally to the nearest switching office by a dedicated pair

Determine lower and upper cut-off frequency, Q. In an amplifier, the maximu...

Q. In an amplifier, the maximum voltage gain is 1500 and occurs at 1kHz. It falls to 1060.5 at 20kHz and at 20Hz. Determine (i) lower cut-off frequency (ii) upper cut-o

Transistor in the common base configuration, Draw the circuit of transistor...

Draw the circuit of transistor in the common base configuration. Draw the Active, saturation and cut-off region. List the characteristics of Ideal Op-Amp. Sketch the pin diagram

what does quality factor mean, The Quality factor is also explained, as Q....

The Quality factor is also explained, as Q. So it is a number, which shows the lossness of a circuit. Higher the Q, the lower are the losses. The quality factor is calculated o

Current source inverter , Current  Source Inverter (CSI) Current  sour...

Current  Source Inverter (CSI) Current  source  inverter has constant  input  but it  can be  adjusted. In CSI  the amplitude of output  current is  independent of load. The lo

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd