Corrosive properties of caustic, Mechanical Engineering

Assignment Help:

Q. Corrosive properties of caustic?

Sodium hydroxide, more commonly known as Caustic Soda or simply ‘Caustic', is widely used in the petrochemical industry to neutralize acidic process streams. Caustic, under ambient conditions, is typically not particularly corrosive and can be handled in carbon steel or stainless steel equipment. Where product contamination is a concern, stainless steel, nickel alloys or lined carbon steel is often used.


Related Discussions:- Corrosive properties of caustic

Plant layout optimization, How to do matlab coding for computerized relativ...

How to do matlab coding for computerized relative allocation of facilities technique

Important section of fly-overs and underpasses, Important section of fly-ov...

Important section of fly-overs and underpasses: Culverts : A structure having a waterway upto 5 m. Minor Bridge : A structure having a waterway of 6-30 m. Medium Si

Use of stainless steels in welding, Q. Use of Stainless Steels in welding? ...

Q. Use of Stainless Steels in welding? Considerable care must be exercised to obtain sound, crack-free welds. These difficulties are pronounced when welding very high-chromium

Necessity of lubrication , Necessity of Lubrication To lubricate t...

Necessity of Lubrication To lubricate the various parts of engine. The supplementary function of lubrication is to cool and clean the engine parts. To prevent en

Try square-measuring tools , Try Square: It has two straight edge arms at ...

Try Square: It has two straight edge arms at the angle of 90 degree and it is used to check the perpendicularity. A try square is shown in Figure. Figure: Try Square

Heat treating equipment, Heat Treating Equipment: The major equipment...

Heat Treating Equipment: The major equipment for heat treatment is furnace. There are two main categories of furnaces - batch and continuous. The furnace selection needs cons

Calculate the induction motor efficiency, Question: Characterisation te...

Question: Characterisation tests have been performed on a four pole, 415 V (line to line), three phase, star connected, 50Hz induction motor, with the following results:

Open and closed position of the armature and flux linkage, Q.   For an elec...

Q.   For an electromagnetic system, show that the energy stored in a magnetic field is equal to the area enclosed b/w magnetization curves for open and closed position of the armat

What are the reasons behind poor pick-up of motor cycle, (a) Why does engin...

(a) Why does engine overheat and what will happen if engine overheats? (b) Why engine does not start in wet or damp weather? (c) What may be the causes if engine dose not sta

Calculate the maximum bending moment, A shaft is supported on bearings A an...

A shaft is supported on bearings A and B, 800 mm between centres. A 20° straight tooth spur gear having 600 mm pitch diameter, is located 200 mm to the right of the left hand beari

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd