Control function in production management, Mechanical Engineering

Assignment Help:

Control Function in Production Management:

Controlling is a sub system of the production system where a part of the output is monitored for feedback signals to give corrective action, if required. The management and control of inventory is a general problem to all kinds of organisations. Inventory control refers to the planning for optimum quantities of materials at all of the stages in the production cycle and evolving techniques which would make sure the availability of planned inventories.

Quality control assures that resulting product shall perform its intended function. Thus, this is concerned with the prevention of defects so that items can be made right at the first time. To attain this several activities are needed to perform. Inspection and control of raw materials ensure that they meet specification. Statistical quality control (SQC) attempts to evaluate machines, materials by observing capabilities and trends in variation so that continual analysis and production can be made to the wanted quality level.


Related Discussions:- Control function in production management

Design, Hi I am new tutor here Pankaj kumar I got the mail for the verif...

Hi I am new tutor here Pankaj kumar I got the mail for the verification and i regitered now . But how can i get the sample assignment for the further process.

Evaluate the resultant of magnitude and direction of force, Evaluate the re...

Evaluate the resultant both in magnitude and direction of the four force acting on the body as shown in figure given below :

Thin cells, what type of stresses a thin cell is subjected to?

what type of stresses a thin cell is subjected to?

What is manifolds, Manifolds The surface of a solid must satisfy some c...

Manifolds The surface of a solid must satisfy some conditions so that the resulting solid is well-behaved. This is the so-called manifold condition. While recent research has s

Force - mechanics, Force - Mechanics: Sometime we push the wall, then ...

Force - Mechanics: Sometime we push the wall, then there are no changes in position of wall, but no doubt we apply a force, as the applied force is not sufficient to move the

Workshop disciplines for general safety, WORKSHOP DISCIPLINES Followin...

WORKSHOP DISCIPLINES Following discipline tips should be made a part of life to become a good technician. These will certainly help in creating safe, friendly and clean enviro

Process planning, what is importance of process planning?

what is importance of process planning?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd