Conceptual engineering phase in project development, Mechanical Engineering

Assignment Help:

Q. Conceptual engineering phase?

During this phase, a conceptual engineering estimate will be prepared by Project Management with input from all disciplines.

Activities at this stage are primarily ‘Process Engineering' driven, with the other discipline providing support for process optimization purposes, leading to the development of the Design Basis Memorandum (DBM).

The deliverables for Mechanical Engineering normally include, but are not limited to, support for development of the following:

• Design Basis Memorandum (DBM) Input

• Plot plan

• Conceptual sketches

• Preliminary sizing and material selection

• Equipment layout sketches

• Conceptual studies

• Conceptual cost estimates

• Preliminary equipment list


Related Discussions:- Conceptual engineering phase in project development

Explain system and parting sand, Q. Explain System and Parting sand? S...

Q. Explain System and Parting sand? System Sand: In mechanized foundries, where machine moulding is employed a so called "system sand" is used to fill the whole flask. Since

Car body, which car body are the most hard when crash never unbroken part. ...

which car body are the most hard when crash never unbroken part. can you explain this answer obviously sir

Bending stress, What is bending stress? The bending moment at section t...

What is bending stress? The bending moment at section tends to bend or deflect beam and internal stresses resist its bending. The process of bending stops when the cross sectio

What is the use of spindle in radial drilling machine, What is the use of S...

What is the use of Spindle in Radial drilling machine    The spindle holds the drill or cutting tools and revolves in a fixed position in a sleeve.

Determine the value of registers, The ARM microprocessor has 32 bit instruc...

The ARM microprocessor has 32 bit instructions and 32 bit registers. Explain why this means that immediate addressing cannot be used to load a register with a 32 bit constant. T

Determine the upward thrust, A vessel is in the shape of a truncated cone h...

A vessel is in the shape of a truncated cone having diameter of 1 meter at the top and 2 meter at the bottom and height 2 meter. If it is fully filled with water determine the upwa

Determine lifting load of crane, Navy divers are called to rescue a group o...

Navy divers are called to rescue a group of office workers trapped in a basement under floodwater in Leeds, UK. The only access to the basement is via a 1.5 x 1.5 m horizontal hatc

Mechatronics, what is plc and how does it works

what is plc and how does it works

Resource management for project, Q. Resource Management for project? An...

Q. Resource Management for project? An important factor in overall project success is the provision of suitable and adequate resources. The initial estimate of engineering man

Stellite-alloys for cutting tools, Stellite This is an alloy of Co as ...

Stellite This is an alloy of Co as 40-60%, Cr as 25-35%, W as 4-25% and C as 1-3%. This is a cast alloy comprising C, W, and Cr in Cobalt matrix. Its major characteristic is l

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd