Classification of i.c. engines - thermodynamics, Mechanical Engineering

Assignment Help:

Classification of I.C. Engines:

IC engines are classified as follows:

1. Nature of thermodynamic cycles as:

 Otto cycle engine, Diesel cycle engine and Dual combustion cycle engine

2. Type of the fuel used:

 Petrol engine, Diesel engine, Gas engine and Bi-fuel engine

3.   Number of strokes as

 Four stroke engine and Two stroke engine

4. Method of ignition as:

 Spark ignition engine, known as SI engine and Compression ignition engine, known as C.I. engine

5. Number of cylinder as:

 Single cylinder engine and Multi cylinder engine

6. Position of the cylinder as:

Horizontal engine, Vertical engine Vee engine, In-line engine and Opposed cylinder engine

7. Method of cooling as: Air cooled engine and Water cooled engine

 


Related Discussions:- Classification of i.c. engines - thermodynamics

Calculation of seismic response loads, Q. Calculation of seismic response l...

Q. Calculation of seismic response loads? The seismic design requirements and the specification of criteria variables for the calculation of seismic response loads for the desi

Diffrence between external diameter and internal diameter, Diffrence betwee...

Diffrence between external diameter and internal diameter: A compound tube is built by shrinking one tube on another, the ultimate dimension being, 80 mm internal diameter, 16

Open belt drive, Open belt drive: An open belt drive connects the two...

Open belt drive: An open belt drive connects the two pulleys 120cm and 50cm diameter on parallel shafts which are apart 4m. The maximum tension in belt is 1855.3N. Coefficien

Evaluate force by replacing equivalent force, Evaluate force by replacing e...

Evaluate force by replacing equivalent force: In designing lifting hook, the forces acting on horizontal section through B can be determined by replacing F by equivale

Illustrate cetane and octane rating of the fuels, (a) Illustrate cetane and...

(a) Illustrate cetane and octane rating of the fuels (b) Compare two adn four stroke cycle engines.

Type of lubrication systems , Type of Lubrication Systems The complete...

Type of Lubrication Systems The complete lubrication of a vehicle can be divided into two systems. (a) Engine lubrication system. (b) Chassis lubrication system.

What are wall footings, What are wall footings? Explain in short. Gener...

What are wall footings? Explain in short. Generally wall footings are required to support direct concentric loads. However, an exception is the wall footings for retaining wall

Find out the power - hollow shaft, Find out the power - hollow shaft: ...

Find out the power - hollow shaft: A hollow shaft of internal diameter 400 mm & external diameter 450 mm is needed to transmit power at 120 rpm. Find out the power it may tran

Material selection for insulation, Q. Material Selection for Insulation? ...

Q. Material Selection for Insulation? Material for 15ºC to 650ºC temp range is Calcium Silicate, Manville Thermo-12 or approved equivalent. Material for -18ºC to 230ºC temp.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd