Chassis lubrication system, Mechanical Engineering

Assignment Help:

Chassis Lubrication System : This lubrication system consists of outer body parts, which are lubricated from outside of the body.

Table of Lubrication Points Sl. No.

Name

Type of Lubricant

1

Ball Bearing

Grease

2

Speedometer Gear

Grease

3

Engine

Engine Oil

4

Main Stand

Grease

5

Brake Pedal

Grease

6

Drive Chain

Oil

7

Front Fork

Oil

8

Throttle grip

Grease

9

Steel Balls, Cone Race,

Grease

10

Ball Race

Grease

 

 


Related Discussions:- Chassis lubrication system

Efficiency test on sand blasting, Efficiency Test on Sand Blasting:   ...

Efficiency Test on Sand Blasting:             After the study on sand blasting, the result was acceptable and the next step is planning to make order for new machine and searc

Equlliberum, what is equilibrium of rigidity?

what is equilibrium of rigidity?

Find the location of the centroid, Find the Location of the Centroid a...

Find the Location of the Centroid a)  Write the integrals for the determination of the location of the centroid of the area shown in Figure-(a).  Only set up the integral.

Find out the maximum and minimum bending stress in beam, Q.  A steel bar 10...

Q.  A steel bar 10 cm broad and 8 mm thick is subjected to bending moment. The radius of the neutral surface is 100 cm. Found out the maximum and minimum bending stress in beam.

Find out the reactions at hinge, Find out the reactions at hinge: A bo...

Find out the reactions at hinge: A board ABCD is held in position as shown in Figure by a cable BE and a hinge at A. If the weight of the board is 5 kN, find out the reactions

Plate oil separator, Plate oil Separator: Check for plate oil separator fi...

Plate oil Separator: Check for plate oil separator fitment.

Describe inversion and mechanism, Describe Inversion and Mechanism. Illustr...

Describe Inversion and Mechanism. Illustrate in detail all inversions of 4-Bar chain Mechanism. (a) Explain all the types of constrained motion with examples. (b) Explain in

What is clad plate and overlay welding, Q. What is Clad plate and overlay w...

Q. What is Clad plate and overlay welding? Strip back cladding on clad plate a minimum of 5 mm (3/16") from the edges of weld preparation before welding on the backing plate.

Operation and maintenance of airport facilities, Operation and maintenance ...

Operation and maintenance of airport facilities: The operation and maintenance of airport facilities is very important for ensuring safety, convenience and economy. Air Traffi

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd