Calculate the vertices for a translated triangle, Mechanical Engineering

Assignment Help:

A triangle PQR with vertices P(2,1), Q(4,4) , R(1,3) is to be translated by 2 units in x - direction and 4 units in y direction. Using the homogenous coordinate system, calculate the coordinates of vertices for a translated triangle.

What are the required Hardware elements of a typical CAM/CAD ?


Related Discussions:- Calculate the vertices for a translated triangle

What do you mean by issued for review, Q. What do you mean by Issued for Re...

Q. What do you mean by Issued for Review? This drawing issue of P&IDs is a draft and is intended for the Colt-internal review process involving affected disciplines. This draw

Plate clutch pressure height-clutch slipping, Plate clutch pressure height ...

Plate clutch pressure height : Check plate clutch pressure leg height by placing the plate clutch pressure on the surface plate. Plate clutch pressure should not tilt on the surfa

The leader command-autocad, The Leader Command The Leader command can b...

The Leader Command The Leader command can be used to annotate at any point on a drawing. The command sequence below was used to draw the leader shown in the Figure Below.

Use of high temperature materials in furnaces, Q. Use of high temperature m...

Q. Use of high temperature materials in Furnaces? Often, furnace tubing and refractory protected membrane walls are fabricated from plain carbon steel with a minimum of 0.25% c

What is a special feature of the pdes, A special feature of the PDES A ...

A special feature of the PDES A special feature of the PDES development is the use of the formal language EXPRESS for modeling the product information. There will be capabiliti

Compression ratio-bottom dead centre, Compression Ratio (r): It is th...

Compression Ratio (r): It is the ratio of the total cylinder volume when the piston is at the bottom dead centre, V t to the clearance volume, V C . R= v t /v c

#power plant, Components of power plant &it''s functions

Components of power plant &it''s functions

Form tool design, I want to make a form tool for lathe for making a convex ...

I want to make a form tool for lathe for making a convex groove of 3 mm radius. tool material will be tungsten carbide. I want to know the dimensions of tool. What is the procedure

Hot And Cold Working, What Are Difference Between Hot And Cold Working

What Are Difference Between Hot And Cold Working

Volume fraction of fibres, Volume fraction of fibres: The epoxy materi...

Volume fraction of fibres: The epoxy material is prepared to be stressed to its full strength. What must be volume fraction of fibres? Solution Here σ′ = 1200 MPa,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd