Calculate the temperature at the center of the pipe, Mechanical Engineering

Assignment Help:

Heat generated uniformly in Stainless steel plate having k=20 W/m.⁰C. The thickness of the plate is 1cm and the heat generation rate is 500 MW/m³. If the two sides of the plate are maintained at 100 and 200 ⁰C respectively, calculate the temperature at the center of the pipe?

Related Discussions:- Calculate the temperature at the center of the pipe

Business Management techniques, how do I Create appropriate costing systems...

how do I Create appropriate costing systems and techniques for specific engineering business functions.

Compute the angular velocity of bar, Compute the angular velocity of bar: ...

Compute the angular velocity of bar: A bar AB as shown in slides so that its bottom point A has a velocity of 4 m/sec to the left along the horizontal plane. Compute the veloc

Can you use motor oil in a hydraulic system, Hydraulic fluid has to pass a ...

Hydraulic fluid has to pass a dissimilar set of standards than motor oil. Motor oil has tackifiers, lower sulfur content, and other ingredients that could solve harmful to the seal

Corrosion in steam condensate system, Q. Corrosion in Steam Condensate Syst...

Q. Corrosion in Steam Condensate System? Carbon dioxide and oxygen, either acting alone or in combination, account for the majority of steel corrosion problems in the condensat

FLUID MECHANICS, A mix of spherical particles of different sizes is to be s...

A mix of spherical particles of different sizes is to be separatedinto two size ranges by passing a liquid of density 1200 kg m-3 and viscosity 0.0015 Pa s upward through the mixtu

Find out the power - hollow shaft, Find out the power - hollow shaft: ...

Find out the power - hollow shaft: A hollow shaft of internal diameter 400 mm & external diameter 450 mm is needed to transmit power at 120 rpm. Find out the power it may tran

What are objectives of the footings, What are objectives of the footings? ...

What are objectives of the footings? Objectives of the footings: After studying this unit, you should be able to: a. Know different types of footings and the situation wh

Bevel gear and shaft analysis, I have a bevel gear and shaft and I want to ...

I have a bevel gear and shaft and I want to know the maximum load that can be applied on it. also I have no information about it, what kind of information is needed for this calcul

Ignition, how does catalytic ignition operate

how does catalytic ignition operate

Represent moment graphically - mechanics, Represent moment Graphically: ...

Represent moment Graphically: How you represent moment Graphically? Sol.: Consider force F which is represented in magnitude and direction, by line AB . L

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages