Calculate the standard time, Mechanical Engineering

Assignment Help:

a) The total estimated time for an operation ie assembly of a pin is 2 minutes. If the rating is 120% determine normal time. If total allowances allowed are 10% for that job, calculate the standard time.

b) Why is it important to maintain time standards? Also mention limitations of time study.


Related Discussions:- Calculate the standard time

Benefits of a good layout and design of plant, Q. Benefits of a good layout...

Q. Benefits of a good layout and design? The benefits of a good layout and design cannot be overemphasized. They provide an irreplaceable safety factor throughout the life of t

Describe stochastic printing, Question: (a) Describe stochastic printin...

Question: (a) Describe stochastic printing and provide three benefits of this printing technique. (b) Though offset printing is the most common form of mass printing and pub

Explain the working of radial drilling machine, Normal 0 false ...

Normal 0 false false false EN-IN X-NONE X-NONE MicrosoftInternetExplorer4

Evaluate the normal and tangential stresses, Evaluate the normal and tangen...

Evaluate the normal and tangential stresses: Q. 20: At the point in stressed body, the principal stresses are σ x = 80 kN/m 2 and σ y = 40  kN/m 2 . Determine the norma

Find out the safe power transmitted by pulley, Find out the safe power tran...

Find out the safe power transmitted by pulley: A belt drives pulley of 200mm diameter such that ratio of tensions in tight side and slack side is 1.2. If maximum tension in b

What is the pull required on brake arm to stop wheel, A simple band brake p...

A simple band brake performs on a drum of 600mm in diameter that is running at 200 r.p.m. The coefficient of friction is 0.25. The brake band has a contact at 270 o one end is fas

Determine the residual plastic strain in the members, As part of the fitti...

As part of the fitting of the mooring lines to a wave energy device, the pin-jointed structure shown in Figure Q is to be subjected to a small degree of plastic deformation by appl

Frames, Frames: You have been introduced to the analysis of frames. By...

Frames: You have been introduced to the analysis of frames. By going through this unit, you may identify frames and differentiate them from trusses. The method for analyzing f

How will you measure the engine oil level?, (a) Why do we change the engine...

(a) Why do we change the engine oil at periodic intervals? (b) What are the recommended instructions to change engine oil? (c) How will you measure the engine oil level?

Determine the maximum stress developed in the beam, Determine the maximum s...

Determine the maximum stress developed in the beam: An I section in Figure is utilized as a beam. The beam is subjected to a bending moment of 2.5 kN m at its neutral axis. De

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd