Calculate the reactive power and current supplied, Mechanical Engineering

Assignment Help:

Question:

A series resistive inductive load is energised from a 240V (RMS), 50Hz single phase AC supply, such that the load draws 1200W at a power factor of 0.8.

a) Calculate the reactive power and the current supplied to the load.

b) Sketch a phasor diagram for this load condition, showing all circuit voltages and currents.

c) Calculate the capacitance value (μf) required to be placed in shunt with the RL load so as to achieve unity power factor as seen by the supply.

Related Discussions:- Calculate the reactive power and current supplied

Resistance welding processes, RESISTANCE WELDING PROCESSES The followin...

RESISTANCE WELDING PROCESSES The following five are the main types of resistance welding: 1. Spot welding 2. Seam welding 3. Projection welding 4. Upset butt we

Product Design and Development, I need a work to be done in the field of te...

I need a work to be done in the field of technical function generation for a product development process and about 3000-3500 words on any theoretical topic related to product devel

Age-hardening of aluminium alloys, Age-hardening of Aluminium Alloys I...

Age-hardening of Aluminium Alloys In specific alloys precipitation from a single phase may arise. The precipitate phase might be in form of determine sub-microscopic particles

Alignment of a railway line - railways, Alignment of a Railway Line: ...

Alignment of a Railway Line: Selection of Alignment The following points must be considered in selecting the alignment of a railway line : (a) It should be as direct

Sizing a Motor that has a cable Pulley, I am stumped as to how to figure th...

I am stumped as to how to figure this out. It is a motor with a cable pulley to move the carriage in a wave tank. (the part that pulls the boat, etc). I have to build it on paper

Maximum efficiency, A jet strikes tangentially a smooth curved vane moving ...

A jet strikes tangentially a smooth curved vane moving in the similar direction as the jet, and the jet gets reversed in the direction. Prove that the maximum efficiency is slightl

Determine the centroid of the area, Determine the centroid of the area: ...

Determine the centroid of the area: Determine the centroid of the area OBDC Solution The trapezium area is divided in two simple areas, (i) A 1 = Rectangle

Introduction to entrepreneurship development , INTRODUCTION: In the previo...

INTRODUCTION: In the previous unit, you studied about the motorcycle and its various parts and systems. In this unit, we shall learn the various aspects of Entrepreneurship Develo

Heat transfer.., Ask question #Minimum 100 woHeat generated uniformly in St...

Ask question #Minimum 100 woHeat generated uniformly in Stainless steel plate having k=20 W/m.0C. The thickness of the plate is 1cm and the heat generation rate is 500 MW/m3. If th

The motorcycle , Motorcycle, we have learnt about the various parts of a mo...

Motorcycle, we have learnt about the various parts of a motorcycle and their functions. Technical specifications of various models of motorcycles launched by the HHML were also not

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages