Calculate the power of the engine, Mechanical Engineering

Assignment Help:

A Torsion dynamometer is used in a propeller shaft of a marine Engine. It is found that the shaft twists 2o in a length of 20 meters at 120 r.p.m. If the shaft is hollow with 300 mm internal diameter and 400 mm external diameter, Calculate the power of the engine. Take modulus of rigidity as 80GPa.


Related Discussions:- Calculate the power of the engine

Calculate the temperature at the center of the pipe, Heat generated uniform...

Heat generated uniformly in Stainless steel plate having k=20 W/m. 0 C. The thickness of the plate is 1cm and the heat generation rate is 500 MW/m 3 . If the two sides of the plate

Calculate density of completely dry oak, The density of a sample of oak is ...

The density of a sample of oak is 0.90 g/cm^3. Calculate             a. the density of completely dry oak             b. the percent water in the original sample

Magnitude of frictional force after perfect rolling begins, What is the mag...

What is the magnitude of frictional force after perfect rolling begins and why? solution) After pure rolling begins,frictional force is 0. This is because the velocity of he c

Cyclic service for vessels, Q. Cyclic Service for vessels? The required...

Q. Cyclic Service for vessels? The required service for all vessels shall include consideration of cyclic service. Batch operation vessels, for example, quite frequently fall i

Hydrostatic law for incompressible and compressible fluid, Illustrate Newto...

Illustrate Newton's law of viscosity. Explain the importance of viscosity in fluid motion. Describe the effects of temperature on viscosity of water and that of air? Discuss hyd

HINT, WRITE THE SHORT NOTES ON SLUDGE AND SCALE

WRITE THE SHORT NOTES ON SLUDGE AND SCALE

Equilibrium diagram, what do understand by the term equilibrium diagram

what do understand by the term equilibrium diagram

Ultrasound bolt load monitoring, Q. Ultrasound Bolt Load Monitoring? Ul...

Q. Ultrasound Bolt Load Monitoring? Ultrasound measurement of bolt stresses, using ‘Bolt Scope', should be used on: • All bolts tightened by tensioning. • All bolts in hy

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd