Calculate the amount sand-aggregate, Mechanical Engineering

Assignment Help:

Calculate the amount of cement, sand, aggregate, and water needed to create a concrete mix with a 28-day compressive strength of 34 MPa for a 10 m x 10 m x 0.25 m structure given the following conditions: allowed slump = 10 cm and only 3.8 cm (1.5 in) aggregate with 2% moisture and coarse sand with 4% moisture are available for this project. Assume no air entrainment in your calculations.


Related Discussions:- Calculate the amount sand-aggregate

Determine the axial extension along a load, Determine the axial extension a...

Determine the axial extension along a load: An open coiled helical spring is created having 10 turns of a mean radius of 60 mm. The wire diameter is 10 mm and coils make an an

Frames, Introduction and conclusion on frames

Introduction and conclusion on frames

Find out the friction force, Find out the friction force: The cord pas...

Find out the friction force: The cord passes over a massless and frictionless pulley, carrying a mass M 1 at one end and wrapped around a cylinder of mass M 2 which rolls on

Moments and forces, 3. A string of length l is fastened to two point A and ...

3. A string of length l is fastened to two point A and B at the same level at a distance ‘a’ apart. A ring of weight W can slide on the string and a horizontal force P is applied s

What is the spindle and drill, What is the spindle and drill The spindl...

What is the spindle and drill The spindle and drill head assembly the taper hole can be create on radial drilling machine with some special attachment likewise quill(The spindl

Illustrated about the term bending moment, Illustrated about the term bendi...

Illustrated about the term bending moment? Bending Moment The critical section for bending moment for masonry or concrete block walls is half-way between the centre line and

Derive the characteristic equations of motion, Derive the characteristic eq...

Derive the characteristic equations of motion for the underdamped, critical damped and overdamped free damped vibration system. Write short notes on i. Fourier series and har

Main features of laser cutting process, Main Features of Laser Cutting Proc...

Main Features of Laser Cutting Process   1) Laser cut kerf is very narrow resulting in material saving. 2) Has very narrow heat affected zone (HAZ) and therefore gives low

Carnot cycle, what is mimnimum data for modelling a unique carnot cycle

what is mimnimum data for modelling a unique carnot cycle

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd