Battery components , Mechanical Engineering

Assignment Help:

Cell Connectors

A cell connector connects the nearby cell with two terminals of opposite polarity (sign). Post strap connect the plates to the terminal.

Electrolyte

This is the solution of sulphuric acid and distilled water of specified gravity.

Container

It is a hard rubber container divided into compartments with partitions for different cells.

Filler Caps

A filler cap with an air vent is provided for the escape of gases.

 

 


Related Discussions:- Battery components

Clutch complaints by repairing of motorcycle , Clutch Complaints Natur...

Clutch Complaints Nature of complaints could be that of following : (a) Clutch judder (jerking) (b) Clutch slipping (c) Half clutch noise

Determine the value of registers, The ARM microprocessor has 32 bit instruc...

The ARM microprocessor has 32 bit instructions and 32 bit registers. Explain why this means that immediate addressing cannot be used to load a register with a 32 bit constant. T

Types of holons, Types of Holons The four major types of holons are: ...

Types of Holons The four major types of holons are: Order holons Product holons Resource holons Staff holons Considering the cooperative aspect of the

Conversion of pressure reading into kpa, Conve r t following reading of p...

Conve r t following reading of pressure to kPa, supposing that the barometer reads 760mm Hg. (1) 90cm Hg gauge (2) 40cm Hg vacuum (3) 1.2m H 2 O gauge Sol: Given

Automobile, what is internal combustion engine

what is internal combustion engine

Performance of heat engine - thermodynamics , Performance of Heat engine: ...

Performance of Heat engine: Performanc e of HP:   It is measured by thermal efficiency that is the degree of useful conversion of heat received into work.

Resultant of non coplanar concurrent force system, Resultant of Non coplana...

Resultant of Non coplanar concurrent force system: How do you find resultant of Non coplanar concurrent force system? Sol.: The resultant of non concurrent force system

Principal stress and strain, The end gear is subjected to the loading given...

The end gear is subjected to the loading given in the picture below. If the bearings A & B exerts only Z & Y component of forces on the shaft, Verify the equilibrium torque T at ge

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd