Auto cad, engineering, Assignment Title: Die Press Assembly Drawing The objective of, Other Engineering

Auto cad, engineering, Other Engineering

Assignment Help:

Assignment Title: Die Press Assembly Drawing

The objective of this assignment is to demonstrate the following concepts of design.

• Extrude
• Revolve
• Fillet
• Dimensioning
• Tolerance
• Basic shaping processes
• Basic joining processes
• Basic modeling and sketching techniques

Tasks that need to be done:

1. Report

Write a report about the concepts of mechanics in Section 1(a) of report. Your report should include a brief introduction and summary, as well as a list of references. Marks will be allocated for proper formatting, including these elements:-
- Report must have introduction, section headers and summary
- Pages of the report must be properly numbered
- Report must include a table of contents
- All figures and tables must be properly labeled and referenced in the text
- Properly citing sources of information using the Harvard Name System of Referencing
- Report should be written in about 2500 words [8 marks]

(a) Explain the concepts of design listed below and describe it in the form of a statement.
• Extrude
• Revolve
• Fillet
• Dimensioning
• Tolerance
• Basic shaping processes
• Basic joining processes
• Basic modeling and sketching techniques [32 marks]

(b) Perform a simple practical work in laboratory on design software which helps you to demonstrate the algorithm for Die Press Assembly Drawing as shown below.
(i) Write the algorithm for the drawing. [10 marks]
(ii) Draw 2D drawing with proper dimensioning. [5 marks]
(iii) Draw 3D drawing with proper dimensioning. [5 marks]
(iv) Assembly drawing with proper dimensioning. [10 marks]

Die Press Assembly Drawing

Note: - All dimensions are in mm
2. Demonstration

Describe and demonstrate the experiment which you have performed in front of your class. [30 marks]

Note: Student has to submit hard copy & soft copy of report in the form of CD also.

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages

Auto cad, engineering, Other Engineering

Related Discussions:- Auto cad, engineering

Subtraction of two 16-bit numbers, write a programme of subtraction of two ...

Dischage rate, stuck on a project that requires 5 outputs with 6 inputs and...

Divided entrance duct - aircraft engine, Divided entrance duct On a sin...

Signal and system, if the response of a signal is h(t) then the cascading o...

Interest rate calculations, Interest Rate Calculations In considering ...

Financial management, I have a homework assignment with 12 present value an...

Dislocations, What are impurities

Power systems, WHY VOLTAGE GENERATED IN MULTIPLES OF 11

Aviation legislation - registration of aircraft, Aviation legislation - REG...

Operations research, degeneracy in transportation problem

Write Your Message!

Featured Services

Online Tutoring

Project Development

Exam Preparation

Course Help

Assignment Help

Popular Subjects

Assured A++ Grade

Academics

Major Subjects

Majors

Get In Touch

TERMS & POLICIES

HELP & SUPPORT