Addressing model , Electrical Engineering

Assignment Help:

Addressing Model

As we have learned  already  that each instruction has two  parts  one is  op code and another  is operand. Op code  specified  the type  of operations to be performed  and  operand  is data  on which  the operation is to  be performed. There are various  ways  of specifying  the operands  in8085 instructions. The way the  operand  is specified in the instruction is  called  addressing  mode. 8085  micro processing  has followings  addressing  modes.


Related Discussions:- Addressing model

Unit impulse response of a linear system, Q. The unit impulse response h(t)...

Q. The unit impulse response h(t) of a linear system is h(t) = 5e -t cos(2t - 30°). Determine H(s).

Measure phase angle by using an oscilloscope, 1. Introduction : ...

1. Introduction : Theory:  Phase angle is defined as the number of degrees separating two sine waves of the same frequency. The Phase shift is defined as any change t

Advantages of an rc coupling over a direct coupling, Q. What are the advant...

Q. What are the advantages of an RC coupling over a direct coupling? Draw a basic Rc coupling network and explain. Figure -RC-coupled transistor amplifier The network

Determine the mechanism of generation of the voltage, (a) Identify the semi...

(a) Identify the semiconductor type in the above diagram. (b) Explain the mechanism of generation of the voltage V AB in the above diagram. (c) An experimental setup like th

Stc set carry instruction, STC Set Carry Instruction This instruction ...

STC Set Carry Instruction This instruction  sets   the carry  flag  to 1. The  instruction format is STC Flags except carry no other  flags are affected

Communication network, Assuming that the receiver sends a XOFF signal when ...

Assuming that the receiver sends a XOFF signal when the receive buffer is P% full in order to avoid any data or packet loss.

Compute the area of each plate, Q For a parallel-plate capacitor with plate...

Q For a parallel-plate capacitor with plates of area A m 2 and separation d m in air, the capacitance in farads may be computed from the approximate relation Compute the a

Earthing in electricity and gas hazards, Earthing : Any electrical applian...

Earthing : Any electrical appliance with a metal casing or with metal parts, likely to be touched by an operator is potentially dangerous. The danger is that an internal or extern

Determine angle between incident ray and reflected ray, Assume a ray of lig...

Assume a ray of light is incident on a smooth reflecting surface at an angle of incidence of 15 degrees to the normal. What is the angle between the incident ray and the reflected

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd