Reference no: EM131164048
In order to complete this part of the assignment you should refer to the laboratory sheet on SunSpace concerning the calculation of inertia of a flywheel.
You are not required to do the experiment or write up the introductory parts of the report. However you should analyse the data provided below as if you had obtained it by doing the experiment and write up your report accordingly.
During the course of the experiment a set of weights were hung in turn on a piece of cord from a pulley attached to the flywheel. The objects were allowed to fall under gravity from a height of 1 metre, as described in the laboratory sheet.
|
Total weight (including hanger) (N)
|
1st descent
time (s)
|
2nd descent
time (s)
|
3rd descent
time (s)
|
|
3.2
|
29.69
|
34.60
|
34.60
|
|
6.0
|
24.25
|
24.28
|
25.22
|
|
8.5
|
19.60
|
19.70
|
19.95
|
|
11.0
|
17.60
|
17.06
|
17.29
|
|
13.5
|
15.12
|
15.65
|
15.12
|
This was performed three times and the data recorded is shown in the table below. The diameter of the spindle d (= 2r) was found to be 38 mm (0.038 m).Complete the following tasks:
a) The flywheel dimensions are as follows: diameter = 390mm, mean thickness = 30mm. Also, it is made of steel, with density 7850 kg/m3. Use this information to estimate the inertia, by considering the formula for the inertia of a solid disc. This value should be used as an approximate validation of the inertia derived in part (b).
b) Critically analyse the tabulated data and use it to determine the inertia of the flywheel and the frictional torque Tf. You should use Excel to calculate and tabulate relevant values, and to plot P x r versus α, as per the laboratory sheet.
|
Find the displacement response of the valve
: Find the displacement response of the valve from its rest position when the cam applies the force F for the first time.
|
|
Determine the gravity force w that can be sustained by the
: Determine the gravity force W that can be sustained by the force F acting on the piston of the Figure. 2. Neglecting the mass of the container find the force F tending to lift the circulartop AB. 3. For isothermal air at O °C, determine the pressure ..
|
|
Draw the hasse diagram of a
: Draw the Hasse diagram of A. Give a subset of B that is linearly ordered and contains at least three elements.
|
|
Plateau in the organization
: Is it better to tell a person that he or she has reached a plateau in the organization or to allow the person to maintain hope of eventual promotion?
|
|
Write up the introductory parts of the report
: Critically analyse the tabulated data and use it to determine the inertia of the flywheel and the frictional torque Tf. You should use Excel to calculate and tabulate relevant values, and to plot P x r versus α, as per the laboratory sheet.
|
|
Provide specific empirically supported treatments
: Conduct a brief (2-3 articles) literature review, searching for empirically supported treatments that would support the particular integrative techniques and interventions that you are using.
|
|
Problems faced by dual employed couples
: What advice would you offer today's employees regarding the problems faced by dual employed couples?
|
|
Determine the maximum acceleration of the piston
: A crank, con rod and piston mechanism is shown below. Determine the maximum acceleration of the piston when the crank speed is 30 rev/min clockwise
|
|
Find the response of the anvil
: have a total mass of m. The support elastic pad has a stiffness of k. If the force applied by the hammer is given by Fig. 4.58
|